Page 1
Installation Instructions for AX-CAM6V
Axxess Integrate
AX-CAM6V
12-volt to 6-volt Step-Down Converter
CONNECTIONS TO BE MADE
• Connect the Black wire to ground.
• Connect the Blue/White wire to the 12-volt reverse wire.
• Connect the Blue/Red wire to the factory camera power wire.
INTERFACE COMPONENTS
• AX-CAM6V converter/harness with stripped leads
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
FEATURES
• Converts 12-volts DC to 6-volts DC to provide proper voltage
for a 6-volt factory backup camera.
CAUTION!
Metra recommends disconnecting the negative battery terminal before beginning any installa
-
tion, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for
more information. All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling the ignition. Also, do not remove the factory
radio with the key in the on position, or the vehicle running. It would be best to remove the key from the
ignition and then wait a few seconds before removing the factory radio.
Page 2
AX-CAM6V
Axxess Integrate
IMPORTANT
If you are having difficulties with the installation of this product,
please call our Tech Support line. Before doing so, look over the
instructions a second time, and make sure the installation was
performed exactly as the instructions are stated. Please have the
vehicle apart and ready to perform troubleshooting steps before
calling.
Loading...