Axxess AX-ADCT2 Installation Instructions Manual

AX-ADCT2

INSTALLATION INSTRUCTIONS

The AX-ADCT2 should be installed on a stereo’s speaker

output wires or the output wires on an OEM amplier of up to 80
watts per channel. These wires can be found behind the stereo
in the dash, on the outside of an OEM amplier, or on the input

terminals on the OEM speakers.

Wire Color & Function:

The audio input wire colors are an EIA

standard for car stereo applications as follows:

YELLOW = BATTER Y +12V Input
BLACK = GROUND Input
BLUE = REMOTE +12V Output

THE ABOVE POWER WIRES CAN BE CONNECTED DI­RECTLY T O THE AMPLIFIER BEING ADDED
WHITE = LEFT Front (+) Input

WHITE/BLACK = LEFT Front (-) Input
GRAY = RIGHT Front (+) Input
GRAY/BLACK = RIGHT Front (-) Input

BLACK/WHITE = Reference Ground (-) (REFERENCE

GROUND OPTIONAL IF NOISE IS PRESENT)
NOTE: Be sure that all audio input connections are polarized or

in phase with each other. That is, the positive output wires from

the audio source need to be connected to the corresponding

positive input wires of the AX-ADCT2. The same goes for the

negative audio wires. Failure to do this will result in poor bass
response and low quality audio.

AX-ADCT2

The AX-ADCT2 is designed to convert 2 channels of

speaker level audio into 2 channels of line level audio.
This allows for the installation of line level products
such as ampli ers, EQs and crossovers on systems

that do not have RCA line level outputs. In addition

this device will also detect the presence of an audio
signal and then generate a +12V output (veri ed by

an illuminated LED) that can be used to turn-on an

aftermarket ampli er.

Features:

80 Watts Maximum Input, Input Circuit Corrects

Crossover Distortion Commonly Found On Other

Brands of LOCs, 6:1 Step Down with Variable Output,

Gold Flashed RCAs, Attractive & Durable Enclosure.

The AX-ADCT2 will shut off 60 seconds after no signal

detected.