Page 1
INSTALLATION/OWNER'S MANUAL
AXS SERIES
Car Audio
AXS609
AXS612
AXS514
Page 2
2
Safety Guidelines
Thank you for purchasing the AXS Series car speakers. Although Axxera has attempted to
make sure all of the information contained within this manual is accurate, please be aware
that any part of it is subject to change without notice.
The following instructions should be used as a general guideline only.
If you are unsure about performing any of the procedures listed
below, please consult a professional car audio installation center.
Before installation, please follow these guidelines:
1. Be sure to carefully read and understand the instructions before attempting to install
this product.
2. For safety, disconnect the negative terminal from the battery prior to beginning the
installation.
3. Use the highest quality connectors for a reliable installation and to minimize signal or
power loss.
4. Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel lines,
brake or hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.
5. Never run speaker wires underneath your vehicle. Running speaker wires inside the
vehicle provides the best protection from exhaust heat and environmental elements.
6. Avoid running wires over, near, or through sharp edged surfaces. Use rubber grommets
to protect any wires routed through metal.
7. When running the speaker cable from the amplifier, avoid running it near sources of
high current (i.e. wiring harnesses, battery cables).
PREPARATION
Page 3
3
INSTALLATION
Wiring
•Connect the speaker wires to the input connection on each crossover connector,
making sure to maintain proper polarity (positive & negative).
•Connect the two red/black spades on the output side of each crossover connector to
the red and black tweeter wires.
•Connectthetwouncoloredspadesontheoutputsideofeachcrossoverconnectorto
the woofer.
Crossover
Connectors
Input
(To Radio)
Output
(To Speakers)
Page 4
4
INSTALLATION
Mounting
1. Determine where the speakers will
be mounted. Make sure the area is
large enough for the speaker to mount
evenly. Also ensure the mounting
location is deep enough for the
speaker to fit.
2. Refer to the specification chart to
determine the proper diameter hole to
cut for your speaker model.
3. If needed, use the grille frame as a
template to mark the locations for the
mounting screws. Drill the holes with a
3/32" bit.
4. Fit the speaker to the hole cut-out.
Mount the frame and speaker using
the supplied screws. Once the frame
and speaker are secured, insert the
mesh cover into the frame.
Mounting
Hole
Frame
Speaker
frame
Page 5
5
OPERATION
AXS612 speakers come with two adapter rings to facilitate a seamless fit into a variety of
different openings.
1. The main adapter ring allows the AXS612 to be mounted in an oversized 6 3/4" hole
as shown in the diagram below. To use this adapter ring, secure the adapter ring to
the vehicle using sheet metal screws, then attach the speaker to the ring with the
machine screws provided.
2. The second adapter ring is a simple spacer that enables AXS612 to be mounted into
the smaller 6" hole that is commonly found in some import cars. It is held in place
when the speaker is mounted and cannot be mounted by itself. New mounting holes
may need to be drilled in order to use this spacer.
Adapter Installation
Typical Door Installation
Typical Rear Deck Installation
Rear Deck
Page 6
6
OPERATION
The above diagram is to be used with the specifications matrix guide below. Design and
specifications subject to change without notice.
Specifications
Model Size Type
Power Rating
(RMS/Peak)
Sensitivity
Frequency
Response
Cutout Diameter Top Mounting Depth
AXS609 6x9" 2-Way 100W/650W 97dB 45Hz-18kHz
8.74"x6.06"
(222mm x 154mm)
3.54" (90mm)
AXS612 6.5" 2-Way 60W/400W 94dB 60Hz-18kHz
5.63"
(143mm)
2.17" (55mm)
AXS514 5.25" 2-Way 45W/300W 92dB 65Hz-18kHz
4.57"
(116mm)
2.32" (59mm)
Page 7
7
OPERATION
This warranty gives you specific legal
rights. You may also have other rights
which vary from state to state. Dual
Electronics Corp. warrants this product
to the original purchaser to be free from
defects in material and workmanship for
a period of one year from the date of the
original purchase.
Dual Electronics Corp. agrees, at our
option, during the warranty period,
to repair any defect in material or
workmanship or to furnish an equal
new, renewed or comparable product
(whichever is deemed necessary) in
exchange without charges, subject to
verification of the defect or malfunction
and proof of the date of purchase.
Subsequent replacement products are
warranted for the balance of the original
warranty period.
Who is covered?
This warranty is extended to the original
retail purchaser for products purchased
from an authorized Dual dealer and used
in the U.S.A.
What is covered?
This warranty covers all defects in
material and workmanship in this product.
The following are not covered: software,
installation/removal costs, damage
resulting from accident, misuse, abuse,
neglect, product modification, improper
installation, incorrect line voltage,
unauthorized repair or failure to follow
instructions supplied with the product, or
damage occurring during return shipment
of the product. Specific license conditions
and copyright notices for the software can
be found via www.dualav.com.
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s
manual. A slight adjustment of any custom
controls may save you a service call.
2. If you require service during the
warranty period, you must carefully
pack the product (preferably in the
original package) and ship it by prepaid
transportation with a copy of the original
receipt from the retailer to an
authorized service center.
3. Please describe your problem in writing
and include your name, a return UPS
shipping address (P.O. Box not acceptable),
and a daytime phone number with your
shipment.
4. For more information and for the
location of the nearest authorized service
center please contact us by one of the
following methods:
•Callustoll-freeat1-866-382-5476
•E-mailusatcs@dualav.com
Exclusion of Certain Damages: This
warranty is exclusive and in lieu of any
and all other warranties, expressed or
implied, including without limitation the
implied warranties of merchantability and
fitness for a particular purpose and any
obligation, liability, right, claim or remedy
in contract or tort, whether or not arising
from the company’s negligence, actual or
imputed. No person or representative is
authorized to assume for the company
any other liability in connection with the
sale of this product. In no event shall the
company be liable for indirect, incidental or
consequential damages.
Limited One-Year Warranty
Page 8
Dual Electronics Corp.
TollFree:1-866-382-5476
Monday-Friday, 9AM-5PM EST
www.axxeraaudio.com
©2013 Dual Electronics Corp.
NSA0413-V01
Loading...