Axxent LP100, LP100STD, LP100LED User Manual

I N T E R C O M - S Y S T E M S

axxent signal lights

The broadest selection of intercom call signal lights
is oered by axxent. The original model LP100 with
conventional 30 volt bulbs has been complimented
earlier by colour LED lights. Now an extremely bright
lighting stroboscope light with 10 high performance
LEDs is available. In line with customer preferences
the LED light is transparent and neutral in colour, due
to the fact that todays high performance stage lighting
systems could optically override a colour LED.

The models

call lights

LP100

With 30 volts bulbs and matt dome. 3 pin XLR
in- and out connectors for standard microphone
cables, looping in to the intercom line. Stable
surface placement with rubber feet. Size of the
base 12.2 x 9 x 5,4 cm (l x w x h). Dome height
4 cm. Net weight 446 g.

LP100LED red

LED signal light with 4 high performance LEDs in
red colour with con-tinuously variable brightness
(just with the help of a little screw driver). This
model is low profile in height due to use of flat­ly shaped LED covers. Like the other lights, the
LP100LED is equipped with 2 standard 3 pin XLR
connectors (female and male) for looping in to the
intercom line. Dimension of the base: 12.2 x 9 x 4.4
cm (l x w x h). The LED dome height merely is 5
mm, the net weight of the unit equals 363 g.

The models LP100LED green, LP100LED yellow,
LP100LED orange only dier from the model
LP100red in the colour of the LEDs.

LP100STD

LP100STD call signal strobe light with 10 high performance
LEDs and transparent dome. This light has a slightly lower
profile compared to the LP100. Standard 3 pin XLR connec­tors (female and male) for looping in to the intercom line.
This light is of special interest to users preferring a maxi­mum signal visibility. Size of the base 12.4 x 9 x 4.4 cm (l x
w x h). Dome height 3,5 cm. Net weight 363 g.

All axxent signal light have in common:

• Compatible to axxent partyline intercom systems,
however, they also work flawlessly with most of the
other commonly available partyline systems.

• They use a voltage of approx. 30 volt DC, derived
from the XLR connectors. oltage may drop to 24 volts
DC without causing a problem.

Pin layout of the 3 pin XLR connectors: Pin 2 = plus
30 volts, Pin 1 = minus 30 volts pin 3 serves as loop
through of the intercom signal.

axxent e.K. · Technologiezentrum Herzbachtal · Zum Wartturm 15 · 63571 Gelnhausen

Fon: [phone] · Fax: [phone] · [e-mail] · www.axxent.de