Axor r 10100801 User Manual

09/2005

HANSGROHE PRODUCT SERVICE

SINGEL LEVER LAV MIXER

Ref. No.: 10100801

Installation
Starck

Installation (1)

Attention: The mixer must connected to angle valves with integrated filter.

The mixer can not used together with a continuous flow water heater.

1. Flush through the supply pipes.

2. Place the mixer including the sealing washer in position on the basin.

3. Slip the slide washer, washer and collar nut over the threaded base and tighten the
collar nut by hand.

4. Tighten screws.

5. Connect the connecting hose to the angle valves; cold right - hot left.

6. Install the battery (please see Exchange battery)

Large differences in pressure between the hot and cold water supply should be balanced.

Operation

The water temperature is adjusted by the adjusting lever.
swivel forward = hot water,
swivel backward = cold water.

Adjustment (2)

This mixer have following feature:
background fade-out with integrated range adjustment, that means the mixer is automati­cally adjusted on to the local conditions (washbasin, brightness, reflection) by the sensory
mechanism.

Exchange battery (3)

The mixer operates with a 6 V Lithium-Battery
(DL 223A). The working life of the battery is 2 years by extremely operation. Over night
the current consumption is reduced by a economy mode.
Push a small hexagon socket screw key into the hole at the backside of the mixer and pull
the cover upwards. Take care to the O-ring.
Attention: After installing the battery, the mixer may not activated for 1 min because of

adjusting itself.

Cleaning washbasin (4)
Cover the infrared sensor by hand, after 4 s remove slowly the hand , the automatic
water stop is activated for 1 min.

adjusting lever

infrared sensor with
light emitting diode
(LED)

cover

1

2

3

7 7/8"

+3/8"

coldhot

09/2005

HANSGROHE PRODUCT SERVICE

Spare parts

LED-Display

LED off: normal operation
LED light: replacing battery
LED flashes every 2 s: water stop is activated

Technical data

Operation pressure: max. 117 psi
Recommended pressure: 14.7 - 72.5 psi
Test pressure: 232 psi
Hot water temperature: max. 176 ° F
Recommended hot water temperature: 149 ° F
Rate of flow: 1,7 gpm by 45 psi
Maximum flowing-out temperature at 122 ° F
temperature difference and 45 psi flow pressure:108 °F
Follow-on time: 1,5 s
Rise-delay time: 300 ms
Automatic switching-off: after 1 min
battery: 6 V / 1300 mAh Lithium

1 battery 97399000
2 connecting hose
3 battery box with cover 96317800
4 areator 94005800
5 fixation set 13961000

1

3

5

2

4