Axor E 75 3-Jet, E 75 2-Jet, E 120 3-Jet User Manual
Installation Instructions / Warranty
Wallbar Sets
Unica’E
06890XX0
Clubmaster
04044XX0
Croma E 75 3-Jet
06494XX0
Croma E 75 2-Jet
06496XX0
Raindance E 120 3-Jet
Monsoon II
04043XX0
04098XX0
Unica’E Wallbar
Follow the installation instructions
(see page 4) when drilling the
mounting holes.
Croma E 75 3-Jet
Croma E 75 2-Jet
Clubmaster
06510XX1 vacuum
breaker -- included with
04043XX1, 04044XX1,
04098XX1 only
2
Raindance E 120 AIR 3-Jet
Monsoon II
Technical Information
Croma E 75 3-Jet handshower 2.5 gpm
Full, massage, turbo massage
Croma E 75 2-Jet handshower 2.5 gpm
Full, turbo massage
Clubmaster handshower 2.5 gpm
Full, massage, soft aerated
Raindance E 120 AIR handshower 2.5 gpm
AIR, Whirl AIR, Balance AIR
Monsoon II handshower 2.5 gpm
Full, massage, turbo massage
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
•
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
•
that you have all tools and supplies needed to complete the installation.
The screws and anchors included with this set are suitable for use in a tile or other solid
•
surface wall. They are not suitable for use in an acrylic or fiberglass shower enclosure.
Please contact the manufacturer of the enclosure regarding recommended mounting locations, reinforcement requirements, and mounting hardware.
This unit does not include a wall supply. Use Hansgrohe model 27458XX3 or another
•
supply that complies with ASME A112.18.1/CSA B125.1 including ASME A112.18.3.
In Massachusetts, the maximum output temperature of the shower valve can be no higher
•
than 112°F.
3
Wallbar installation
Remove the screw covers from the wallbar.
Position the wallbar in the desired location. Mark
the positions of the screw holes (1).
Place the wallbar in a safe location.
Drill the holes with a 6 mm bit (2).
Do not drill into existing water
lines!
1 2
(3) Install the anchors.
Seal the wall around the anchors
with waterproof sealant.
Failure to seal the wall can lead
to possible water damage.
Install the wallbar using the screws and washers.
Install the screw covers.
Install the soap dish (optional).
3
4
Loading...