Axor 39236XX1, 39136XX1, 39156XX1 User Manual

Installation Instructions / Warranty

Citterio

39136XX1
39156XX1

Citterio

39236XX1

2

Axor Citterio Widespread Lav Mixer 39136XX1
Axor Citterio Bidet Mixer 39236XX1

39136XX1 39236XX1

39156XX1

User instructions

Turn the right handle forward (clockwise) to
turn the cold water on. Turn the handle back
(counter-clockwise) to turn the cold water off.

Turn the hot handle forward (counter-clockwise)
to turn the hot water on. Turn the hot handle
back (clockwise) to turn the hot water off.

Technical Data

Recommended hole size
spout 1 3/8“
valves 1 1/4“
Maximum depth of mounting surface 1 1/8“
Flow rate @ 45 psi 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120oF - 140oF*

*Some municipalities limit the maximum water temperature from the water heater to 120o or below. Please
know and follow all applicable local codes when setting the temperature on the water heater.

Prepare to install the faucet:

Prior to installation, install the supply stops.

Hot and cold supply lines and nuts are not included with the faucet. They must be purchased
separately by the plumber or by the consumer.

Flush the supply lines thoroughly. Damage to the faucet caused by debris in the water line is not
covered under the limited lifetime warranty.

Assembly

• Install the valves to the lavatory.

• Install the valve mounting screws, but do

not tighten them.

• Install the spout to the handle assembly.
Use a 5 mm allen wrench to install and
tighten the spout retaining screws.

• Place the spout and handle assembly
over the valve bodies. Tighten the valve
mounting screws.

• Install the drain pull rod. Place the spout
mounting piece and the nut over the
threaded shank on the bottom of the spout
assembly. Tighten the nut.

3