Axor 39233XX1, 39235XX1, 39135XX1, 39133XX1 User Manual

Installation Instructions / Warranty

Axor Citterio

39133XX1

Axor Citterio

39233XX1

Axor Citterio

39135XX1

Axor Citterio

39235XX1

2

Axor Citterio Widespread Lavatory Faucet
Axor Citterio Widespread Bidet Faucet

39133XX1 / 39135XX1

39233XX1 / 39235XX1

Technical data

Hole size in mounting surface
Spout 1 3/8“
Valve 1 1/4“
Max. thickness of mounting surface 1 3/16“
Max. flow rate 2.2 gpm
Operating pressure: max. 147 psi
Recommended operating press.: 14.7 - 72.5 psi
Test pressure: 232 psi
Hot water temperature: max. 176° F*
Recommended hot water temp.: 120°F - 140°F*

*Please know and follow all applicable local plumbing codes when setting the temperature on the water
heater. In Massachusetts, the water heater may be set no higher than 112oF.

Installation Considerations

Hansgrohe recommends that this faucet be installed by a licensed, professional plumber.

This faucet requires 1/2“ supply lines (not included)

Flush the hot and cold supplies thoroughly before installing this faucet.

Installation

Flush the supplies thoroughly before
installation.

Install the metal washer and friction washer on
the valve. Push the valve up through the hole
in the mounting surface. Install the mounting
plate.

Rest the valve assembly on the mounting sur­face. Tighten the screws.

Place the handle assembly over the valve with
the lever or cross in the desired off position.
Hold the lever or cross steady with one hand.
With the other hand, thread the escutcheon
down over the mounting plate.

Assemble the spout: Push the escutcheon
onto the bottom of the spout (1). Fasten the
retaining screws with a 5mm allen wrench (2).
Push the pull rod down through the spout.

3