Axor 39154XX1, 39234XX1 User Manual

Installation Instructions / Warranty

Citterio

39134XX1
39154XX1

Citterio

39234XX1

2

Axor Citterio Widespread Lav Mixer 39134XX1, 39154XX1
Axor Citterio Bidet Mixer 39234XX1

39134XX1

39154XX1

39234XX1

Technical Data

Recommended hole size
spout 1 3/8“
valves 1 1/4“
Maximum depth of mounting surface 1 1/8“
Flow rate @ 45 psi 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120oF - 140oF*

*Some municipalities limit the maximum water temperature from the water heater to 120o or below. Please
know and follow all applicable local codes when setting the temperature on the water heater.

Prepare to install the faucet:

Prior to installation, install the supply stops.

Hot and cold supply lines and nuts are not included with the faucet. They must be purchased
separately by the plumber or by the consumer.

Flush the supply lines thoroughly. Damage to the faucet caused by debris in the water line is not
covered under the limited lifetime warranty.

• Install the valve bodies to the lavatory.

• Install the spout to the handle assembly.

Use a 5 mm allen wrench to install and
tighten the spout retaining screws.

• Place the spout and handle assembly
over the valve bodies. Tighten the valve
mounting screws.

• Install the drain pull rod. Place the spout
mounting piece and the nut over the
threaded shank on the bottom of the spout
assembly. Tighten the nut.

3