Axor 39144XX1 User Manual
Installation / Warranty
Citterio
39144XX1
Citterio
39148XX1
90614801 02/2006
Axor Citterio Wall Mount Lav Mixer with Cross Handles
39144XX1
Axor Citterio Wall Mount Lav Mixer with Lever Handles
39148XX1
39144XX1 39148XX1
Technical Data
Flow rate @ 45 psi 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120oF - 140oF*
*Some municipalities limit the maximum water temperature from the water heater to
120o or below. Please know and follow all applicable local codes when setting the
temperature on the water heater.
Installation Consideration
Rough-in 10303181 must be installed, and the wall finished, prior to
installation of this trim kit.
For the trim to fit properly, the outside surface of the finished wall must fall
between the “minimum” and “maximum” lines on the factory installed plaster
shields on the rough-in. If the rough-in is too far inside the wall, install
extension kit 96259000 (purchased separately) before attempting to install
the handle trim.
No drain is included with this trim kit. Please consult the sink manufacturer
regarding a suitable drain for the specific sink used.
· Remove the inserts from the hot and
cold plaster shields.
· Cut the plaster shields so that they
extend 1/16” from the wall. Seal
around the shields with a suitable,
non-staining, waterproof bathroom
sealant.
· Lever handle version only:
Remove the hot and cold
cartridges using a 17 mm deep
socket wrench. Replace them
with the turn ceramic cartridges
included with the trim kit. The hot
cartridge is marked with notches
on the wrench flats.
· On the spout outlet, measure the
distance from the brass rough-in
to the end of the plaster shield.
Record this measurement (“X”).
Add 1 7/8” to this measurement.
Measure the spout adapter. Mark
a point X + 1 7/8” from the oring end of the adapter. Cut the
adapter at this point.
· Wrap the threads with several
layers of Teflon® thread tape.
Screw it into the spout port.
· Measure the distance from the
plaster shield to the end of the
spout adapter. It should measure
1 3/8”.
Loading...