Turn the right handle forward (clockwise) to
turn the cold water on. Turn the handle back
(counter-clockwise) to turn the cold water off.
Turn the hot handle forward (counter-clockwise)
to turn the hot water on. Turn the hot handle
back (clockwise) to turn the hot water off.
Technical Data
Recommended hole size
spout 1 3/8“
valves 1 1/4“
Maximum depth of mounting surface 1 1/8“
Flow rate @ 45 psi 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120oF - 140oF*
*Some municipalities limit the maximum water temperature from the water heater to 120o or below. Please
know and follow all applicable local codes when setting the temperature on the water heater.
Prepare to install the faucet:
Prior to installation, install the supply stops.
Hot and cold supply lines and nuts are not included with the faucet. They must be purchased
separately by the plumber or by the consumer.
Flush the supply lines thoroughly. Damage to the faucet caused by debris in the water line is not
covered under the limited lifetime warranty.
Page 3
Assembly
• Install the valves to the lavatory.
• Install the valve mounting screws, but do
not tighten them.
•Install the spout to the handle assembly.
Use a 5 mm allen wrench to install and
tighten the spout retaining screws.
•Place the spout and handle assembly
over the valve bodies. Tighten the valve
mounting screws.
•Install the drain pull rod. Place the spout
mounting piece and the nut over the
threaded shank on the bottom of the spout
assembly. Tighten the nut.
3
Page 4
4
•Place a compression nut and ferrule over
the spout tube.
•Install the mounting angle. Tighten the
compression nut by hand, then finish
tightening with a wrench.
•Screw the hot and cold connection hoses
to the mounting angle.
•Place a compression nut and washer over
the shank end of one of the connection
hoses.
•Attach the hose to the outlet port on the
valve with the compression fitting. Tighten
with a wrench. Repeat with the other
connection hose.
•Install the supply hoses (not included) and
connect them to the stops.
•After the drain is installed, turn on the
water and check all connections for leaks.
Page 5
Install the pop-up drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the
threads with plumbers’ thread tape and replace.
Install the white, flexible sealing gasket to the
flange. Place it in the sink outlet.
From under the sink, install the black mack gasket, white friction ring and retainer nut to the
flange. Do not tighten the nut against the bottom
of the sink at this time.
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
plunger
height adjuster
flange
sealing gasket
mack gasket
Tighten the retainer nut.
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes
through the loop in the bottom of the height
adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the
horizontal rod.
Attach the swivel connector to the end of the
pull rod. Position as desired and tighten with a
small, flathead screwdriver.
XX = Color code
00 chrome plated
82 brushed nickel
Cleaning Recommendation for Hansgrohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to
design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered
under the Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’s instructions
when using.
• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause considerable damage
to finishes and to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale buildup and water spot-
ting.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Page 7
Important
• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after use.
• If the surface is already damaged, harsh cleaning materials will cause further damage.
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty
is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in
either the United States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material
or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the
product that proves defective because of improper workmanship and/or material, under normal installation, use, service and
maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made, Hansgrohe
may elect to refund the purchase price in exchange for the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences.
If you are a consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty
extends for as long as you own the product and the home in which the product is originally installed. If you purchased the product
for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1
year, with respect to Hansgrohe and Commercial products, and (ii) for 5 years, with respect to AXOR products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper maintenance,
misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no-rinse” cleaning
products, or the use of the product in any manner contrary to the product instructions. (3) Conditions in the home such as
excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for installation
or reinstallation of the product (including but not limited to proper packaging and shipping costs), or for installation or reinstallation of the product.
D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your Hansgrohe retailer, or contact Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Toll-free (800) 334-0455.
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492
Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
7
Page 8
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED
UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES
NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH
THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR
CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY
(INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring
any action in court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to
installing, always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product.
If you have questions at any time about the use, installation, or performance of your Hansgrohe product, or this warranty, please
call or write to us or call us toll-free at 800 334 0455.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004
Tel. 770 360-9880 • Fax 770 360 9887
www.hansgrohe-USA.com
US - Installation Instructions • Part No. 90650801 • Revised 05/2007
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.