Axor 38840XX1 User Manual
Installation Instructions / Warranty
2
Uno
38840XX1
Uno2 Two-handle Sink Faucet
38840XX1
Installation Considerations
Be sure that you have all tools and supplies necessary before beginning the installation.
The supply hoses on this faucet require supply
stops with 3/8” compression fittings (not included).
The spout is convertible. Normally, it will swivel
140o. If the spout stop pin is removed before
installation of the spout, it will swivel a full 360o.
(see step 4 of the installation instructions)
Installer - please leave this booklet for the homeowner as it contains important information about
the faucet.
Technical Specification
Flow rate 2.2 gpm
Max. incoming water pressure 145 psi
Recommended incoming water pressure 14.5 - 72 psi
Max. incoming hot water temp 176
Recommended incoming hot water temp 120
Hole size in mounting surface 1 1/4”
Maximum mounting surface thickness 2 3/8”
Maximum mounting surface thickness with extension 2 7/8”
*know and follow all applicable local plumbing codes when setting the temperature on the water heater.
2
o
F*
o
F - 140oF*
Installation
If the countertop is less than 1 3/8”, install the faucet
with the gray plastic spacer, fiber washer, metal
washer and mounting nut.
1
If the countertop is greater than 1 3/8”, install the
faucet without the spacer.
If the countertop is greater than 2 3/8”, install the
shaft extension.
2
3
3
Loading...