Axor 38053XX1 User Manual

Installation Instructions / Warranty

Uno²

38053XX1

90540801 03/2005

Uno² widespread lavatory faucet
38053XX1

Technical Specification

Maximum water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Maximum hot water temp. 176o*
Recommended hot water temp 120o - 140o*
Max. flow rate @ 45 psi 2.2 gpm
Max. deck thickness 1 3/8”
Hole size in deck valves 1 1/4”

*Many municipalities require that the water heater be set no
higher than 120o. Please know and follow all
applicable plumbing codes when setting the temperature on
the water heater.

Installation considerations:

This unit requires 1/2” supply lines and
nuts, which are not included.

Installation Instructions

spout 1 3/8”

• Push the valve up through the hole in
the mounting surface. Thread the
mounting ring with o-ring on as far as
it will go.

• Pull downward on the valve until the
mounting ring is seated firmly on the
countertop. -Tighten the tensioning
screws.

2

• Thread on the escutcheons with o­rings. Install the red and blue color
rings. Install the white plastic handle
snap connectors with the screws.­Press the handle firmly over the snap
connector and push firmly
downwards.

• Seat the spout assembly with sealing
ring on top of the mounting surface.
From below, thread on the fiber
washer, metal washer, and mounting
nut.

• Make sure that the spout assembly
stands straight. Tighten the
tensioning screws.

• Use the 3/8" compression fittings to
install the connection hoses to the
valve outlets.

• Connect the valves to the angle stops
with ½” supply hoses and nuts.
(Hansgrohe does not provide angle
stops, supply hoses, or nuts.)

3