Axor 38030XX User Manual

Installation Instructions / Warranty

2

Uno

38030XX1

02/2005 9.05406.01

Uno2 Single Control Lavatory Faucet
38030XX1

Technical Specification

Maximum water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Maximum hot water temp. 176o*
Recommended hot water temp 120o - 140o*
Max. flow rate @ 45 psi 2.2 gpm
Max. deck thickness 1 5/8”
Hole size in deck 1 3/8”

*Many municipalities require that the water heater be set no higher than 120o. Please know and follow all applicable
plumbing codes when setting the temperature on the water heater.

Installation considerations:

• Hansgrohe recommends that this faucet be installed by a licensed
professional plumber.

• The supply hoses installed on this unit connect to the supply stops with
standard 3/8" compression fittings. Supply stops and 3/8" compression
fittings are not included.

2

Installation Instructions

• Sit the faucet with black sealing ring in the faucet hole on top of the
mounting surface.

• From beneath, install the friction washer, metal washer, and mounting nut.
Tighten the mounting nut, taking care not to overtighten.

• Check the position of the faucet. When satisfied, use a slot-headed
screwdriver to tighten the tensioning screws.

• Feed the pull rod through the hole in the back of the faucet body.

• Attach the supply lines to the supply stops with standard 3/8" compression

fittings (not included)

sealing ring

friction washer

metal washer

mounting nut

tensioning screws

3