Axor 35033801 Installation Instructions Manual
Starck
10133XX1
Carlton
17135XX1
Steel
35033801
Terrano
37135XX1
Phoenix
17105XX1
Phoenix
17115XX1
Phoenix
17114XX1
Terrano
37136XX1
Phoenix
17104XX1
Carlton
17235XX1
Installation Instructions / Warranty
2
Starck
10133XX1
Phoenix
17105XX1
Phoenix
17104XX1
Phoenix
17114XX1
3
Carlton
17135XX1
Carlton
17235XX1
Phoenix
17115XX1
Steel
35033801
4
Terrano
37135XX1
Terrano
37136XX1
Technical Information
Recommended water pressure 14.7 - 72.5 psi
Max. water pressure 147 psi
Recommended hot water temp. 120° - 140° F*
Max. hot water temp 176ºF*
Hole size - spout 1-3/8"
Hole size - valve 1-1/4"
Max. mounting surface depth see diagrams
Flow rate -- 17104/17105 only 1.5 gpm max.
Flow rate -- all other models 2.2 gpm max.
Requires 1/2" hot and cold supply hoses -- not included
*Please know and follow all applicable local plumbing codes when setting
the temperature on the water heater.
Installation Considerations
For best results, Hansgrohe
recommends that this unit be
installed by a licensed, professional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure that
you have all tools and supplies
needed to complete the installation.
•
•
5
Installation
Starck only
Remove the valve mounting nuts from the valves.
Push the valves up into the holes. Install the mounting nuts
on the valves.
Tighten the tensioning screws.
Place the handles over the valve mounting nuts. Tighten
the handles by rotating the escutcheons clockwise.
The handles should be parallel to the basin.
Install the spout
Position the sealing ring, escutcheon, and spout on the
mounting surface.
Install the mounting flange. Thread the collar onto the
stud and tighten.
Loading...