Axor 34315XX1 User Manual

Installation Instructions / Warranty

Axor Citterio M

34315XX1

2

Axor Citterio M Wall-mount Lavatory Faucet
34315XX1

Technical Information

Max. flow rate 2.2 gpm
Max. water pressure 145 psi
Recommended water pressure 14.5 – 72 psi
Recommended hot water temp. 120°F – 140°F*

*Know and follow all applicable local plumbing codes when setting the
temperature on your water heater.

Installation Considerations

Rough valve 10303181 must be installed. The finished wall must be installed and made wa-

•
tertight before installation of this trim kit.

For best function of this unit, the hot and cold supplies must be of equal pressure.

•
This faucet may be used with a continuous flow water heater as long as the flow pressure is at

•
least 14.5 psi.

For best results, Hansgrohe recommends that this faucet be installed by a licensed professional

•
plumber.

Turn the water off at the main before beginning installation.

•

Installation

Remove the covers.

Trim the plaster shields so that they extend 1/16” outside
the surface of the finished wall

Seal the wall around the plaster
shields with waterproof sealant.

Failure to seal the wall can lead
to possible water damage.

Use a 17 mm deep socket wrench to remove the
cartridges.

Install the new cartridges. The hot cartridge is marked
with notches.

3

4

Push the extension spindle over the stem. Cut the exten­sion spindle so that it extends 3/16” outside the surface
of the finished wall.

Remove the plug from the spout port.

Thread the coupling over the stem. Cut the coupling so
that it extends ¼” outside the surface of the finished wall.

For the spout: Measure the distance between the rough
and the end of the plaster shield Record this measure­ment (“X”).