Axor 34134XX1 User Manual

Installation Instructions / Warranty

Citterio M

34134XX1

2

Axor Citterio M widespread lavatory faucet 34134XX1

34134XX1

Technical Information

Recommended water pressure 14.7 - 72.5 psi
Max. water pressure 145 psi

Recommended hot water temp. 120� - 140� F*
Max. hot water temp 165�F*

Hole size in mounting surface
valves 1 1/4"
spout 1 3/8"
Max. mounting surface depth 1 3/8"
Flow rate 2.2 gpm

*Please know and follow all applicable local plumbing codes when setting

the temperature on the water heater.

Installation Considerations

For best results, Hansgrohe recommends that this unit be installed by a licensed, professional

•
plumber.

Please read over these instructions thoroughly before beginning installation. Make sure that

•
you have all tools and supplies needed to complete the installation.

This faucet can be used with a continuous flow water heater if the flow pressure is at least 20

•
psi. For best service, the hot and cold supplies should be at equal pressure.

This faucet requires 1/2" supply lines (not included).

•

Installation

Install the friction washer and fiber washer on the valve.

Push the valve up through the hole in the mounting surface.

Install the sealing rings, escutcheon, and nuts.

The hot valve is marked with red.

Rest the valve / escutcheon assembly on the mounting
surface (1).

Tighten the screws (2).

Push the handles into place (3).

Push the spout shank up through the mounting surface
(1).

Install the shaft fastening ring (2).

The notch on the shaft fastening ring and the notch
on the shank must face away from the basin.

Install the fiber washer, friction washer, and mounting
nut (3).

3

1

2

2

1

3

3

4

Check the alignment of the handles.

If one is not aligned, pull it off (1), turn it slightly (2), and
reinstall it (3).

2

3

1

Install the glide ring and the o-ring.