Axor 284466XX1 User Manual

Installation Instructions / Warranty

Bodyvette

28466XX1

Bodyvette Bodyspray 28466XX1
Installation

Specification

Flow rate @ 45 psi 2.0 gpm

Required tools

Adjustable wrench
Teflon tape
Waterproof bathroom sealant

Bodyspray Placement

Custom showers are sized to the user(s). Bodysprays are normally placed at the upper
back, middle back, and upper thigh. Always position bodysprays according to the
preferences of the user(s).

Pressure Balancing Loop

If installing bodysprays in
a bank of 3 or fewer, a
pressure balancing loop is
not necessary.

If installing bodysprays in
a bank of four or more, a
pressure balancing loop
must be used to keep the
pressure even between the
bodysprays.

Rough-in Suggestion

This installation requires a 1/2” male threaded pipe fitting recessed 3/8” behind the
surface of the finished wall. The plumber should install a properly anchored 1/2” female

pipe fitting (i.e. a drop-ear ell) recessed into the wall, into which a brass pipe nipple of
proper length can be fitted once the finished wall is complete.

2

Installation Instructions

Install a 1/2” male threaded pipe fitting, recessed
3/8” behind the surface of the finished wall.
Wrap the threads with Teflon tape.

Place the sealing gasket and escutcheon against
the wall. Screw the spray body through the
escutcheon and gasket, and onto the male pipe
fitting. If the pipe fitting is recessed properly, the
spray body will hold the escutcheon firmly against
the wall.

Screw the base body over the spray body.

Push the sprayhead firmly over the spray body.

3