Axor 18213001 Installation Instructions Manual

Installation Instructions / Warranty

Massaud

18013001

Massaud

18213001

2

Massaud Lavatory Faucet
18013001
Massaud Bidet Faucet
18213001

18013001 18213001

3

Product Specification

Max. flow rate 2.2 gpm
Max. incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Max. hot water temperature 176oF*
Recommended hot water temp. 120oF - 140oF*
Hole size in mounting surface
valves 1 1/4”
spout 1 3/8”
Max. thickness of mounting surface 1 3/8”
Lavatory faucet 18013001 includes 10 mm supply hoses. 10 mm - 3/8” adapters included.
Bidet faucet 18213001 requires 1/2” supply lines (not included)

*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts,
the water heater may be set no higher than 112oF.

Installation

Flush the hot and cold supply lines thoroughly before
installing this faucet.

Install the metal washer and friction washer on the valve.
From below the mounting surface, push the valve up
through the hole (1).

Install the o-ring on the upper mounting plate (2).

Secure the upper mounting plate to the valve by turning it
clockwise.

Lower the valve so that the mounting plate rests on the
mounting surface (1). Tighten the screws (2).

4

Turn the cartridge stems so that they are in the “off” posi­tion. Turn the hot stem clockwise, the cold stem counter­clockwise.

Push the red color ring and hot handle firmly over the
hot (left) valve (1). Push the blue color ring and handle
firmly over the cold (right) valve (2).

Install the spout assembly to the center hole (1). From
below the mounting surface, install the fiber washer,
metal washer, and mounting nut (2).