Axor 16534XX1 User Manual

Installation Instructions / Warranty

Axor Montreux

16532XX1

Axor Montreux

16534XX1

2

Axor Montreux Wall-Mounted Widespread Lavatory Set
16532XX1 Cross handles
16534XX1 Lever handles

16532XX1

16534XX1

Technical Information

Recommended water pressure 14.7 - 72.5 psi
Max. water pressure 147 psi

Recommended hot water temp. 120� - 140� F*
Max. hot water temp 176�F*

Flow rate 2.2 gpm

*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.

Installation Considerations

For best results, Hansgrohe recommends that this unit be installed by a licensed, professional

•
plumber.

Please read over these instructions thoroughly before beginning installation. Make sure that

•
you have all tools and supplies needed to complete the installation.

Rough 10303181 must be installed, and the wall surface completed and made watertight

•
before installation of this trim kit.

Installation

Make sure that the water is turned off at the main before
beginning!

Remove the caps from the plaster shields.

Cut the plaster shields so that they extend 1/16" outside
the wall.

Seal the wall around the plaster
shields with waterproof sealant.

Failure to seal the wall can lead
to possible water damage.

Model 16534XX1 only:

Remove the cartridges.

Install the new cartridges included with the trim.

The new hot cartridge is marked with
notches on the wrench flats.

3

4

All models:

Install the extension spindles (1). Cut them so that they
extend 9/16" outside the surface of the wall (2).

Remove the plug from the spout housing (3).

Install the slip couplings (1).

Cut the slip couplings so that they extend 1 5/16" outside
the surface of the wall (2).

Measure the distance between the front of the spout hous­ing and the surface of the wall. Record this measurement
(“x”).