Axor 15101XX1, 15100XX1 User Manual

Installation Instructions / Warranty

Electronic

15100XX1
15101XX1

90576601 07/2005

Electronic Lavatory Faucet with Adjustable Temperature
15100XX1
Electronic Lavatory Faucet
15101XX1

Technical Data

Recommended water pressure 14.5 – 116 psi
Max. incoming hot water temp 120oF – 140oF*
Max. flow rate 2.2 gpm
Automatic turnoff after 35 sec.
Battery Lithium CR-P2/6V
Hole size 1 3/16”
Max. countertop depth 1 3/4”

Installation Considerations

• This unit cannot be used with a continuous flow water heater.

• Large differences in pressure between the hot and cold water supplies should be

balanced.

• Do not twist or kink the supply hoses

• Flush the supply lines thoroughly before installing this faucet. Debris can clog the

filter screens and aerator, causing unsatisfactory flow from the faucet. Debris
problems are not covered under the Hansgrohe warranty.

• The check valves and the filter screens should be checked periodically.

• This faucet does not include a drain.

2

Installation Instructions

• Remove the mounting nut, metal washer, and fiber washer from

the faucet.

• Place the faucet with sealing gasket on top of the sink.(1)

• From beneath the sink, install the fiber washer, metal washer,

and mounting nut (2).

• Install the adapters to the hot and cold stops (3). Attach the

check valves and filter screens to the adapters (4). Attach the
hoses to the check valves (5) using two wrenches, as shown.
Take care not to twist or kink the supply hoses.

Model 15100XX1

• Turn on the water supplies (1). Remove

the protective cover from the sensor (2).
Wait 15 seconds (3).

• Place your hand in front of the sensor to

turn the water on (4).

• Adjust the temperature of the water with

the lever on the side of the faucet. Pivot
it forward to obtain cooler water,
backward to obtain warmer water.

3