Axor 10920001 User Manual
Installation Instructions / Warranty
Starck X
10920001
2
Starck X Waterwall
10920001
Technical Data
Flow rates @ 45 psi
Showerhead 2.5 gpm
Handshower 2.5 gpm
Bodysprays 4.3 gpm
Maximum water pressure 145 psi
Recommended water pressure: 40 - 75 psi
Recommended hot water temp.: 120°F - 140°F*
A check valve is installed in the handshower outlet.
•
The high temperature limit stop may be reset to comply with local plumbing codes. See page
•
5.
This unit is listed by IAPMO and is approved for use in Massachusetts.
•
Please save this document as it contains user, maintenance and warranty
•
information.
*Please know and follow all applicable local codes when setting the temperature on the water heater. In
Massachusetts, the water heater may be set no higher than 112°F.
Preparation
The Waterwall requires 1/2” NPT male nipples, extending 5/8” outside the surface of the finished wall for the
hot and cold water supplies.
For proper operation of the thermostatic mixer, the hot
supply should be on the left and the cold supply should
be on the right.
Finish and seal the wall prior to installation of the
Waterwall.
Flush the supply lines thoroughly before installation.
Installation
Drill the holes for the top and bottom mounting brackets, using a 6 mm bit. Install the anchors. Seal around
the anchors with waterproof sealant.
Screw the mounting brackets to the wall with the screws
provided.
Wrap the threads on the nipples with Teflon tape. Install
the elbows so that the outlets face upwards.
Seal the wall around the nipples and
anchors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.
3
Loading...