Installation Instructions / Warranty
Interaktiv
Retroaktiv
4-Hole Roman Tub Trim
Interaktiv & Retroaktiv 4-Hole Roman Tub Trim
These instructions cover the following trim kits:
Interaktiv
Solaris 06665XX0
Stratos 06667XX0
Metro 06669XX0
Interaktiv S 06876XX0
Retroaktiv
Swing Tango Limbo
Cross handle 06125XX0 06048XX0 06113XX0
Scroll handle 06124XX0 06047XX0 06112XX0
Lever handle 06123XX0 06046XX0 06110XX0
Proaktiv* 06322XX0 06319XX0 06312XX0
*handles not included, sold separately
Installation considerations
4-hole roman tub rough valve 06646000 must be installed, and the mounting
surface completed and made watertight before installation of this trim kit
Backflow prevention is provided by a check valve installed in the handshower
elbow.
Flow rate of handshower 2.5 gpm
Make sure that the water is turned off at the main before installing this trim kit.
Interaktiv
06669XX0 shown
2
Retroaktiv
Swing - Cross handles shown
Tango - Swing handles shown
Limbo - Lever handles shown
3
Install the Handles
Remove the plaster shields from the hot
and cold valves.
Retroaktiv only: Install
the deco rings on the
handles.
All models: Position the
handle over the valve stem
with the lever in the desired
“off” position.
Holding the lever in place with one hand,
use your other hand to turn the “bell” and
screw it down over the valve.
Assemble the Diverter and
Spout
Remove the plaster shield from the spout
tee. Remove the brass plug from the
tee.
4