Axor 06452XX0, 06456XX0, 04172XX0, 06453XX0, 06455XX0 User Manual
...
Installation Instructions / Warranty
ThermoBalance II Deck Valve
Metris S
06401XX0
Metro E
06452XX0
C Lever
06456XX0
Focus S
06405000
Talis S
06453XX0
Solaris² E
04172XX0
Solaris E
06450XX0
C Cross
06454XX0
Allegro² E
04185XX0
Stratos E
06451XX0
C Scroll
06455XX0
Metro² E
04198XX0
ThermoBalance II Deck Valve
06401XX0 Metris S
06405000 Focus S
06450XX0 Solaris E
06451XX0 Stratos E
06452XX0 Metro E
06453XX0 Talis S
06454XX0 C Cross
06455XX0 C Scroll
06456XX0 C Lever
04172XX0 Solaris² E
04185XX0 Allegro² E
04198XX0 Metro² E
06401XX0 06405XX0
06451XX0 06452XX0 06453XX0
06450XX0
06454XX0 06455XX0 06456XX0
2
04172XX0 04185XX0
04198XX0
Technical Specification
Recommended pressure 45 - 72 psi
Maximum hot water temp. 165° F*
Recommended hot water temp. 120° - 140° F*
Flow rate @ 44 PSI 8 gpm
Safety stop 100° F
1/2" female NPT inlets
Maximum mounting surface thickness 1 3/8"
Hole size in mounting surface 2 3/8"
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater.
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
•
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
•
that you have all tools and supplies needed to complete the installation.
The mounting surface must be installed and made watertight prior to installation.
•
For best service of the ThermoBalance valve, the pressure of the incoming hot water and
•
the pressure of the incoming cold water must be equal.
This valve is for a two-function installation. Both outlets must be plumbed. If only one
•
function is to be used, loop the two outlets together. Do not plug either outlet.
Some areas have plumbing codes limiting the maximum output temperature. The high
•
temperature limit stop may be reset to comply with these codes. See page 7.
3
Install the rough
Remove the upper mounting ring.
Screw the lower mounting ring and
washer to their lowest position.
Insert the rough up through the hole.
Install the upper mounting ring.
Tighten it as far as it will go without
forcing it.
Rest the rough on the mounting surface.
Tighten the lower mounting ring and washer.
Tighten the tensioning screws.
upper mounting
ring
sealing ring
washer
lower mounting
ring
washer
lower
mounting
ring
tensioning
screws
Install the plaster shield.
4
Loading...