Axor 04127XX0, 04126XX0, 04136XX0, 04140XX0, 04143XX0 User Manual
...
Installation Instructions / Warranty
Metris S
04135XX0
Metris S
04126XX0
Allegro E
04130XX0
Allegro E
04139XX0
Talis S
04136XX0
Talis S
04127XX0
Metro E
04140XX0
Metro E
04131XX0
Focus S
04137XX0
Focus S
04128XX0
Solaris E
04138XX0
Swing C
04143XX0
Solaris E
04129XX0
Swing C
04134XX0
Two-hole thermostatic tub filler -- requires rough 04125181
04135XX0 04136XX0
04137XX0 04138XX0
04139XX0 04140XX0
04143XX0
2
Three-hole thermostatic tub filler -- requires rough 04124181
04126XX0
04127XX0
04128XX0
04129XX0
3
04130XX0
04131XX0
04134XX0
Technical Information
Recommended water pressure 45 - 72 psi
Recommended hot water temp. 120� - 140� F*
Max. hot water temp 165�F*
Max. flow rate 8 gpm
Max. flow rate – handshower 2.5 gpm
Safety stop 100° F
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
•
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
•
that you have all tools and supplies needed to complete the installation.
The mounting surface must be installed and made watertight prior to installation.
•
The rough must be installed prior to installation of this trim kit.
•
Some areas have plumbing codes limiting the maximum output temperature. The high
•
temperature limit stop may be reset to comply with these codes.
4
Install the valve trim
Push the escutcheon over the valve.
Install the handle. Tighten the screw with a
3 mm Allen wrench. The screw must
engage the slot on the cartridge.
Justify the handle.
Set the high temperature limit stop.
Install the spout
Remove the plug.
slot
Push the spout sealing ring firmly into the spout
adapter (1).
Push the escutcheon and spout over the adapter
and sealing ring (2).
Tighten the screw using a 3 mm Allen wrench (3).
Do not over tighten the set screw.
Over tightening the screw may
damage the o-rings, which will
cause the spout to leak.
3
2
1
5
Loading...