Keezone
Instruction manual
Tested and approved according with
ECE R44 / 04
Child seat
15-25 kg
Car booster cushion
15-36 kg
ank you for choosing a child seat from Axon Kids. e team developing Keezone
has more than 30 years of experience in child safety products in the team totally.
We have done our outmost to make this baby seat as safe as possible. e Axon
Kids child seat has of course also been tested and certied according to ECE R/44
04, the latest European standard for child safety.
To maximize your child’s safety, please observe the following:
Read the instruction manual carefully before you
assemble the baby seat. Otherwise you risk to
expose your child to serious danger.
Important information
Read the instructions carefully before you attempt to install the
seat. If you have any doubts, please contact your store of purchase, which can show you the correct installation. Incorrect installation means danger to your child.
Never mount the child seat in a seat with an active airbag. If you
still wish to use the seat, disconnect the airbag at an authorized
service center, or if your car is equipped with it, use the key to
turn the airbag o. It is important to always note if the car’s indicator shows that the airbag is turned o.
In case of a car accident, no matter how small, always replace
the child seat. It may have invisible damages that seriously affects your child’s safety. is is also the reason for why you never
should buy a used child seat. Axon Kids recommendation is that
you always should buy a new seat in a store.
Never use this child seat in a car seat that is not equipped
with an approved three-point belt.
The child seat’s parts
1. Adjustable headrest
2. Backrest
3. Seat cushion
4. Belt guide for the shoulder belt of the car
5. Pass-through for belt
6. Handle used for adjusting height of headrest
7. Adjustable lever
8. Handle used for adjusting the angle of the seat
9. Pocket for keeping the manual
Installation of the backrest
To assemble the child seat follow these steps.
A) Position the backrest in the rear attachments of the seat cushion, the backrest
should then be put in a horizontal position.
B) Push the guiding pin as far as possible into the seat cushion attachment.
C) Fold up the backrest to an upright position, you know that the assembly
is correctly performed when you receive a “click” sound as conrmation.
WARNING! When you fold the backrest, make sure that no parts are
caught between the seat cushion and backrest
4
Loading...