AXIOMTEK GOT321W-502-PCT, GOT317-502-FR User Manual
GOT321W-502-PCT
All-in-One
21.5” FHD Fanless
10-Point Multi-Touch PANEL PC
User’s Manual
Disclaimers
This manual has been carefully checked and believed to contain accurate information.
Axiomtek Co., Ltd. assumes no responsibility for any infringements of patents or any third
party’s rights, or any liability arising from such uses.
Axiomtek does not warrant or assume any legal liability or responsibility for the accuracy,
completeness or usefulness of any information in this document. Axiomtek does not make any
commitment to update any information in this manual.
Axiomtek reserves the right to change or revise this document and/or product at any time
without notice.
No part of this document may be reproduced, stored in a retrieval system, or transmitted in any
forms or by any means, electronic, mechanical, photocopying, recording, among others,
without prior written permission from Axiomtek Co., Ltd.
CAUTION
Wrong type of batteries may cause explosion. It is recommended that users only replace with
the same or equivalent type of batteries as suggested by the manufacturer once properly
disposing of any used ones.
Copyright 2018 Axiomtek Co., Ltd.
All Rights Reserved
Feb 2018, Version A1
Printed in Taiwan
ii
Safety Precautions
Before getting started, please read the following important safety precautions.
1. Be sure to ground yourself to prevent static charge when installing any internal
components. Use a grounding wrist strap and place all electronic components in any
static-shielded devices. Most electronic components are sensitive to static electrical
charge.
2. Disconnect the power cord from the GOT321W-502-PCT series prior to any installation.
Be sure both the system and all external devices are turned off. Sudden surge of power
could ruin sensitive components. Make sure the GOT321W-502-PCT Series is properly
grounded.
3. Do not open the system’s back cover. If opening the cover for maintenance is a must,
only a trained technician is allowed to do so. Integrated circuits on computer boards are
sensitive to static electricity. To avoid damaging chips from electrostatic discharge,
observe the following precautions:
Before handling a board or integrated circuit, touch an unpainted portion of the
system unit chassis for a few seconds. This will help to discharge any static
electricity on human body.
When handling boards and components, wear a grounding wrist strap available
from most electronic component stores.
Trademark Acknowledgments
Axiomtek is a trademark of Axiomtek Co., Ltd.
Intel® and Pentium® are registered trademarks of Intel Corporation.
Windows 10, Windows 10 IoT Enterprise, Windows 8.1, Windows 8, Windows 7, are
trademarks of Microsoft Corporation.
Other brand names and trademarks are the properties and registered brands of their
respective owners.
iii
Table of Contents
Disclaimers ..................................................................................................... ii
Safety Precautions ........................................................................................ iii
Section 1 Introduction ............................................. 1
1.1 General Descriptions .......................................................................... 1
1.2 Specifications ...................................................................................... 2
1.3 Dimensions and Outlines ................................................................... 5
1.4 I/O Outlets ............................................................................................ 7
1.5 Packing List ......................................................................................... 8
Section 2 Hardware and Installation ...................... 9
2.1 Board Layout ....................................................................................... 9
2.2 Jumper and Connector Settings ...................................................... 10
2.2.1 CLR_CMOS (Clear CMOS Jumper) ......................................................... 11
2.2.2 COM Port Connector ................................................................................ 11
2.2.3 Ethernet Connector ................................................................................. 12
2.3 Mounting Methods ............................................................................ 13
2.4 Hardware Installation ........................................................................ 15
2.4.1 Installing a HDD ....................................................................................... 15
2.4.2 Installing a DRAM .................................................................................... 16
2.4.3 Installing a CPU ....................................................................................... 17
2.4.4 Installing a Wireless LAN Card .............................................................. 18
2.5 Connecting the Power Input ............................................................. 20
Section 3 AMI BIOS Setup Utility .......................... 21
3.1 Navigation Keys ................................................................................ 21
3.2 M.I.T .................................................................................................... 22
3.3 System Information ........................................................................... 23
3.4 BIOS Feature ..................................................................................... 24
3.5 Peripherals ......................................................................................... 25
3.6 Chipset ............................................................................................... 26
3.7 Power Management........................................................................... 27
3.8 Save & Exit ......................................................................................... 29
Section 4 Driver and Installation ......................... 31
4.1 Operating System ............................................................................. 31
iv
4.1.1 Installing System Drivers ....................................................................... 31
4.2 Touch Screen ..................................................................................... 32
Appendix A Watchdog Timer ................................... 33
About Watchdog Timer ................................................................................ 33
How to Use Watchdog Timer ....................................................................... 33
WDT Sample Program ................................................................................. 34
ITE 8620 Datasheet about Watch Dog register description ...................... 35
v
This page is intentionally left blank.
vi
GOT321W-502-PCT User’s Manual
Section 1
Introduction
This Section contains general information and detailed specifications of the
GOT321W-502-PCT, including the following subsections:
Figure 1-1 Front panel of the GOT321W-502-PCT
General Descriptions
Specifications
Dimensions and Outlines
I/O Outlets
Packing List
1.1 General Descriptions
The GOT321W-502-PCT has adopted a 21.5" TFT FHD LCD with 250-nit brightness and
supports LGA1151 Socket 6/7th generation Intel® Core™ i7/i5/i3/Celeron processor that can
support Windows 7, Windows 7 Embedded, Windows 8, Windows 8 Embedded, Windows 10,
Windows 10 IoT and variety applications.
This fanless platform was especially designed for operation in a harsh environment including
steel refinery, oil pipe, ship, machine maker, and many more. With abilities as described below,
the GOT321W-502-PCT has been made an extremely robust and cost-effective solution.
Intel® Skylake/Kaby Lake H110 Platform
Support LGA1151 Socket Intel® Core™ i7/i5/i3/Celeron processors. User can choose different
processors for different applications. It also supports dual DDR4 SO-DIMM up to 32GB
memory modules. There are rich I/O, such as dual power input, swappable 2.5” HDD, USB3.0
port, RS232/422/485,LAN ports, HDMI / VGA / Display port output. This platform is a
power-efficient solution.
Introduction 1
GOT321W-502-PCT User’s Manual
A Design for extended operating temperature range and ingress protection
The GOT321W-502-PCT can sustain extended operating temperature range between 0°C and
+40°C by incorporating compact ID and fanless cooling system. Adopting an IP65 front bezel,
it can also protect itself from liquid and dust. These designs have helped make the system a
power-efficient solution.
Reliable and stable design
The GOT321W-502-PCT is a fanless cooling system, which makes it suitable for vibration
environments, such as the industrial machinery markets. For high capacity storage
requirement, GOT321W-502-PCT can work under 1.0G (10 ~ 500Hz) in operation mode with a
patent of anti-vibration design. The patent improves the system reliability and sustainability.
Multi- PCAP touch surfaceof 7H hardness
The GOT321W-502-PCT is design with a user friendly multi- PCAP touch. Users can operation
it with direct touch. The surface hardness is up to 7H, good for applications of anti-scratch
purpose.
WLAN antenna supported (optional)
The GOT321W-502-PCT comes with two Mini Card slots as an add-on option to connect a
wireless LAN card under 802.11 a/b/g/n protocols, or with other 3G/GPRS applications, etc.
These slots also come with three optional fixed rotational WLAN/3G antennas for wireless
network connection.
Other features
The GOT321W-502-PCT has design with removable HDD tray, let user more convenient to
change it.
NOTE: GOT321W-502-PCT has four kinds of video output, such as HDMI, VGA, DP and
internal LCD panel. Due to chipset (H110) limitation, user only can configure two
displays from BIOS CMOS setting or OS control panel.
1.2 Specifications
Main CPU Board
CPU
Support LGA1151 Socket Intel® 6th/7th generation Core™ i family processor
Support Intel® Pentium® Processor G4xxxx series
System Chipset
Intel® Skylake/Kaby Lake H110
System Memory
2 x 260-pin DDR4-2400 SO-DIMM socket
Maximum memory size up to 32GB
BIOS
AMI UEFI BIOS
2 Introduction
I/O System
Standard I/O
2 x RS-232/422/485
4 x USB 3.0
2 x RJ-45
1 x HDMI 1.4b
1 x VGA
1 x Display Port 1.2
2 x Power input
1 x AT/ATX switch
1 x Remote power switch
1 x Line Out
1 x MIC in
3 x OSD key
1 x Power button
1 x AT/ATX switch
Audio
2 x 3.5 Phone jack (Line out and MIC in)
2 x speakers
Expansion
1 x Mini Card slot (half size for Wi-Fi)
1 x Mini Card slot (full size for mSATA/3G)
Storage
1 x 2.5” SATA HDD
1 x mSATA
Power connector
1 x 3-Pin Phoenix connector
1 x Power DIN connector for Adapter
System Specifications
21.5” TFT FHD LCD. (1920 x 1080)
GOT321W-502-PCT User’s Manual
ten points proj ect capacitive multi -touch
A design of fanless heat dispensation
IP65 aluminum front bezel
Disk drive housing:
One 2.5” SATA drive
Net weight
8.4 Kgs
Dimensions (of the main body)
547.59 x 339.05 x 75.6 mm
Introduction 3
GOT321W-502-PCT User’s Manual
Operating temperatures
0°C to 40°C
Relative humidity
20% to 90% @ 40°C, Non-condensing
System power input
DC power input: 12V/19V/24V DC-in with Phoenix power connector
AC-DC Power (19V adapter)
NOTE: All specifications and images are subject to change without notice.
The performance of the system might be adversely affected at an operating
temperature above 40°C.
It’s highly recommend to use SSD or wide temperature HDD rather than common
HDD.
4 Introduction
GOT321W-502-PCT User’s Manual
1.3 Dimensions and Outlines
Diagram 1-1 shows the dimensions and outlines of the front panel of the GOT321W-502-PCT
Diagram 1-1 Front dimensions and outline of the GOT321W-502-PCT
Front dimensions: 547.59 x 339.05 x 75.6 mm
Introduction 5
GOT321W-502-PCT User’s Manual
Diagram 1-2 Back outline of the GOT321W-502-PCT
Diagram 1-3 Cutting-out dimensions of the GOT321W-502-PCT
Cut out dimensions: 534.69 x 326.15 mm
6 Introduction
GOT321W-502-PCT User’s Manual
1.4 I/O Outlets
Please refer to Figures 1-2 and 1-3 for I/O locations of the GOT321W-502-PCT.
Figure 1-2 Bottom view of the GOT321W-502-PCT
Figure 1-3 Side view of the GOT321W-502-PCT
Figure 1-4 Back view of the GOT321W-502-PCT
Introduction 7
Loading...