AXIOMTEK GOT3187W-881-PCT User Manual

GOT3187W-881-PCT

All-in-One

18.5” WXGA TFT Fanless
Multi-Touch PANEL PC

User’s Manual

ii

Disclaimers

This manual has been carefully checked and believed to contain accurate information.
Axiomtek Co., Ltd. assumes no responsibility for any infringements of patents or any third
party’s rights, and any liability arising from such use.

Axiomtek does not warrant or assume any legal liability or responsibility for the accuracy,
completeness or usefulness of any information in this document. Axiomtek does not make any
commitment to update the information in this manual.

Axiomtek reserves the right to change or revise this document and/or product at any time
without notice.

No part of this document may be reproduced, stored in a retrieval system, or transmitted, in
any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written permission of Axiomtek Co., Ltd.

CAUTION

If you replace wrong batteries, it causes the danger of explosion. It is recommended by the
manufacturer that you follow the manufacturer’s instructions to only replace the same or
equivalent type of battery, and dispose of used ones.

Copyright 2014 Axiomtek Co., Ltd.

All Rights Reserved
Oct 2014, Version A1
Printed in Taiwan

iii

Safety Precautions

Before getting started, read the following important cautions.

1. Be sure to ground yourself to prevent static charge when installing the internal
components. Use a grounding wrist strap and place all electronic components in any
static-shielded devices. Most electronic components are sensitive to static electrical
charge.

2. Disconnect the power cords from the GOT3187W-881-PCT Series before making any
installation. Be sure both the system and the external devices are turned OFF. Sudden
surge of power could ruin sensitive components. Make sure the GOT3187W-881-PCT
Series is properly grounded.

3. Do not open the system’s top cover. If opening the cover for maintenance is a must, only
a trained technician is allowed to do so. Integrated circuits on computer boards are
sensitive to static electricity. To avoid damaging chips from electrostatic discharge,
observe the following precautions:

 Before handling a board or integrated circuit, touch an unpainted portion of the

system unit chassis for a few seconds. This will help to discharge any static
electricity on your body.

 When handling boards and components, wear a wrist-grounding strap, available

from most electronic component stores.

Trademarks Acknowledgments

Axiomtek is a trademark of Axiomtek Co., Ltd.
Windows® is a trademark of Microsoft Corporation.

IBM, PC/AT, PS/2, VGA are trademarks of International Business Machines Corporation.
Intel® and Pentium® are trademarks of Intel Corporation.

AMI is trademark of American Megatrend Inc.
Other brand names and trademarks are the properties and registered brands of their

respective owners.

iv

Table of Contents

Disclaimers ..................................................................................................... ii

Safety Precautions ........................................................................................ iii

Chapter 1 Introduction ............................................. 1

1.1 General Description ............................................................................ 1

1.2 Specifications ...................................................................................... 2

1.3 Dimensions and Outlines ................................................................... 4

1.4 I/O Outlets ............................................................................................ 5

1.5 Packing List ......................................................................................... 6

Chapter 2 Hardware and Installation ...................... 7

2.1 CFast card Installation ................................ ................................ ........ 8

2.2 Open back cover ................................................................................. 9

2.3 Jumper and COM port Connector .................................................... 10

2.3.1 CMOS Clear Jumper (SJP2 on SBC87881) .............................................. 11

2.3.2 DC Power In Connector (SCN1) ............................................................... 12

2.3.3 HDMI Connector........................................................................................ 12

2.3.4 COM Serial Port Connector ...................................................................... 13

2.3.5 Ethernet Connector ................................................................................... 13

2.3.6 Serial ATA Connectors ............................................................................... 14

2.3.7 SIM Card Slots (SCN19) ........................................................................... 14

2.3.8 CFast™ Socket ......................................................................................... 15

2.3.9 Half-Size Express Mini Card Slot (SCN13) ............................................... 16

2.3.10 Full-Size Express Mini Card (w/ SIM Slot)/ mSATA (SCN14) ................... 17

2.4 Mountings: Panel / Wall / Desktop / VESA ...................................... 18

2.4.1 VESA/Wall-Mount ...................................................................................... 18

2.4.2 Panel-mount Kit Assembly ........................................................................ 19

2.5 HDD Installation ................................................................................. 20

2.6 Installing CPU and PCH Thermal Pad .............................................. 22

2.7 DRAM Installation .............................................................................. 23

2.8 Wireless LAN Card Installation ........................................................ 24

2.9 Power Adapter Installation ............................................................... 26

Chapter 3 AMI BIOS Setup Utility .......................... 27

3.1 Starting ............................................................................................... 27

3.2 Navigation Keys ................................................................................ 27

v

3.3 Main Menu .......................................................................................... 28

3.4 Advanced Menu ................................................................................. 29

3.5 Chipset Menu ..................................................................................... 39

3.6 Boot Menu .......................................................................................... 44

3.7 Security Menu .................................................................................... 45

3.8 Save & Exit Menu .............................................................................. 46

Chapter 4 Drivers Installation ................................ 49

4.1 Driver CD/DVD content ..................................................................... 49

4.2 Touch Screen ..................................................................................... 50

vi

This page is intentionally left blank.

GOT3187W-881-PCT User ’s Manual

Introduction 1

Chapter 1

Introduction

This chapter contains general information and detailed specifications of the
GOT3187W-881-PCT. Chapter 1 includes the following sections:

 General Description
 Specifications
 Dimensions and Outlets
 I/O Outlets
 Package List

1.1 General Description

The GOT3187W-881-PCT adopts a 18.5-inch TFT LCD and supports LGA1150 Socket 4th
generation Intel® Core™ i7/i5/i3/Celeron processor that can support Windows 7, Windows 7
Embedded, Windows 8, Windows 8 Embedded and variety applications. This fanless platform
has below abilities make it surely a robust and cost-effective solution.

Intel® Haswell H81 Platform

Support LGA1150 Socket Intel® Core™ i7/i5/i3/Celeron processors. User can choose different
processors for different applications. It also supports up to 8GB DDR3 1333/1600 MHz
memory modules. There are rich I/O, such as dual PCIe mini card slot、2.5” HDD bay、USB3.0

port、RS232/422/485、HDMI output. This platform is a power-efficient solution.

Reliable and Stable Design

The GOT3187W-881-PCT is a fanless cooling system, which makes it suitable for vibration
environments, such as the industrial machinery markets. For high capacity storage
requirement, GOT3187W-881-PCT can work under 1.2G (5 ~ 500Hz, random for CFast card)
in operation mode with a patent of anti-vibration design. The patent improves the system
reliability and sustainability.

GOT3187W-881-PCT User’s Manual

2 Introduction

18.5 Inch WXGA TFT LCD with projected capacitive multi-touch

18.5 inch WXGA TFT LCD is with 300nits higher brightness and can displays contents in HD
resolution. With projected capacitive multi-touch, users can operate more directly and friendly.
The hardness of touch glass surface is up to 7h and is better for anti-scratch purpose.

WLAN Antenna Supported (optional)

GOT3187W-881-PCT has dual PCIe Mini Card slots for optional add-ons such as mSATA
storage、wireless LAN card for 802.11 b/g/n connections or 3G/GPRS applications, and more.

It also provides an optional fixed rotational WLAN antenna (optional) for wireless network
connection.

1.2 Specifications

Main CPU Board

 CPU

 Support LGA1150 Socket Intel® Core™ i7/i5/i3/Celeron processor

 System Chipset

 Intel

○R

Haswell H81

 System Memory

 One 204-pin DDR3 SO-DIMM socket
 Maximum memory up to 8GB

 BIOS

 American Megatrends Inc. UEFI (Unified Extensible Firmware Interface) BIOS

I/O System

 Standard I/O

 2 x RS-232/422/485
 2 x USB 2.0, 2 x USB 3.0

 Video I/O

 1 x HDMI out

 Ethernet

 2 x RJ45 for Giga Ethernet

 Audio

 1 x Line-out
 1 x Mic-in

 Expansion

 2 x Mini-card slot (If you install 3G mini-card, you can’t use mSATA storage card)
 2 x SATA 3 , 2 x SATA 2

 Storage

 1 x 2.5” HDD/SSD Bay
 1 x CFast

slot and mSATA

 Power connector

 1 x 19V DC-IN power connector

GOT3187W-881-PCT User ’s Manual

Introduction 3

System Specification

 18.5” WXVGA(1366x768) LCD with LED backlight & 300nits brightness
 Projected Capacitive Multi Touch
 Fanless Heat Dispensing Design
 IP65 front bezel
 Disk drive housing:

 1x 2.5” SATA drive

 Net Weight

 6.3Kg(13.9 lb)

 Dimension (Main Body Size)

 460x285x89.5mm

 Operation Temperature

 0℃ to 40℃

 Relative Humidity

 20% to 90% @ 40℃, Non-Condensing

 Power input

 19V DC-IN power connector

NOTE All specifications and images are subject to change without notice.
NOTE If the operation temperature is higher than 40℃, the wide temperature HDD/CF

card are recommended to be used on the device.

NOTE If the operation temperature is higher than 45℃, the wide temperature DRAM is

recommended to be used on the device.

GOT3187W-881-PCT User’s Manual

4 Introduction

1.3 Dimensions and Outlines

The following diagrams show the dimensions and outlines of GOT3187W-881-PCT
Outline Dimension: 460x285x89.5(mm)

Cut out: 448.74x237.74mm

GOT3187W-881-PCT User ’s Manual

Introduction 5

1.4 I/O Outlets

Please refer to the following illustration for I/O locations of the GOT3187W-881-PCT.

No

Function

No

Function

1

POWER SWITCH (ATX)

8

2 x USB 2.0

2

Power Input connector

9

2 x USB 3.0

3

Audio Line-out

10

CFast card slot

4

Audio MIC-in

11

For 3 x antennas

5

COM1/2 (RS-232/422/485)

12

LED Backlight Power On/off

6

HDMI output

13

Brightness +

7

Dual Giga Ethernet

14

Brightness -

12

13

14

GOT3187W-881-PCT User’s Manual

6 Introduction

1.5 Packing List

When you receive the GOT3187W-881-PCT, the bundled package should contain the
following items:

 GOT3187W-881-PCT unit x 1
 Driver CD x1
 Panel mount kit x 12
 Screws for HDD x 4
 SATA data cable x 1
 SATA power cable x 1

If you can not find the package or any items are missing, please contact Axiomtek distributors
immediately.

GOT3187W-881-PCT User ’s Manual

Hardware and Installation 7

Chapter 2

Hardware and Installation

The GOT3187W-881-PCT provides rich I/O ports and flexible expansions for you to meet
different demand, for example CF card. The chapter will show you how to install the hardware.
It includes:

 CFast Card Installation
 Open Back Cover
 Jumper & COM Port Connector
 Mounting Method
 Hard Disk Installation
 Installing CPU and PCH Thermal Pad
 DRAM Installation
 Wireless LAN Card
 Power Adapter

GOT3187W-881-PCT User’s Manual

8 Hardware and Installation

2.1 CFast card Installation

The GOT3187W-881-PCT provides one CFast card slot for users to install CFast card. Please
refer to the following instructions for installation:

Step 1 Open the cover, unscrew 2 screws on the chassis.

Step 2 Stick the mylar on the CFast card bottom side.

Step 3 Insert the CFast card to the CFast card slot, then finding the CFast cover and

screw it.

GOT3187W-881-PCT User ’s Manual

Hardware and Installation 9

2.2 Open back cover

This section tells users how to open back cover. Please follow the steps below.

Step 1 Unscrew 6 screws on the back cover. Please refer the drawing below.

Step 2 Remove the back cover.

GOT3187W-881-PCT User’s Manual

10 Hardware and Installation

2.3 Jumper and COM port Connector

SBC87881 Top Side

GOT3187W-881-PCT User ’s Manual

Hardware and Installation 11

Jumper is a small component consisting of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. The following
illustration shows how to set up jumper.

Before applying power to GOT3187W-832-PCT, please make sure all of the jumpers and
switch are in factory default position. Below you can find a summary table and onboard default
settings.

Jumper & Switch Setting

Section

CMOS Clear Jumper

2.3.1

External Connectors

Section

DC Power In Connector

2.3.2

HDMI Connector

2.3.3

COM Serial Port Connector

2.3.4

Ethernet Connector

2.3.5

Internal Connectors

Section

Serial ATA Connectors

2.3.6

SIM Card Slot

2.3.7

CFast™ Socket

2.3.8

Half-Size Mini Card Slot

2.3.9

Full-Size Mini Card w/ SIM Slot/ mSATA

2.3.10

2.3.1 CMOS Clear Jumper (SJP2 on SBC87881)

Function

Setting

Normal (Default)

1-2

Clear RTC

2-3