Axial Racing AX90032 User Manual
4
4
4
11.1v 5000mah
7.4v 5000mah
or
x2
x2
2
7.4v 5000mah
x2
x2
4
4
4
or
11.1v 5000mah
3
Top View Parts
Front Shock
Absorber
Steering Rack
Battery Tray
Steering Servo
Front Bumper
Front Control Arm
Front Body Mount
Electronic Speed
Control (ESC)
Spur/Pinion/Slipper
(Under Cover)
Transmission
Rear Shock
Absorber
Brushless Motor
Battery Door
Rear Swing Arm
Rear Axle
4
Getting-Started Checklist
The following checklist is a guide for getting you vehicle running for the first time.
Read ‘Cautions’ in Manual. Familiarize yourself with vehicle and
its components.
Charge battery pack. Install 4X AA batteries into Transmitter. Turn on transmitter FIRST
Even though the vehicle is new check
driveshaft setscrews and other screws to
make sure they are tight from the factory.
Turn on transmitter FIRST then connect
batteries
Drive vehicle, challenge yourself and
have fun!
Check to make sure steering and throttle
operation work correctly.
Maintain vehicle.
5
Range check radio system.
r
Turn on the transmitte .
1
2
Range-Checking Your Radio System
The radio system should be checked before operating the vehicle to ensure it’s operating properly and has adequate range.
1. Turn on the transmitter first and then the vehicle.
2. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
3. Walk away until you are at the farthest distance you plan to operate the vehicle.
4. Steer the vehicle back and forth and throttle both forward and reverse making sure there is no erratic behavior.
5. If any erratic behavior is exhibited do not operate the vehicle, call customer service for further assistance.
RANGE-CHECKING FOR DISTANCE
THIS VEHICLE DOES NOT HAVE A POWER SWITCH -
ALWAYS DISCONNECT THE BATTERIES BEFORE
TURNING OFF THE CONTROLLER AND WHEN THE
VEHICLE IS NOT IN USE
Place vehicle on a stand or box to
help prevent accidental run-away
Firmly connect both ESC leads to one battery on each side of vehicle
Do not use a Nickel Cadmium or Nickel Metal Hydride battery charger to
charge LiPo batteries. Damage to the batteries and charger will likely
occur resulting in a fire.
Verwenden Sie keine Nickel-Cadmium-oder Nickel-Metall-Hydrid-Akku
Ladegerät LiPo-Akkus aufladen. Schäden an den Batterien und
Ladegerät wird wahrscheinlich auftreten, was zu einem Brand.
Ne pas utiliser un chargeur de batterie au nickel-cadmium ou
nickel-métal-hydrure pour recharger les batteries LiPo. Les dommages
aux batteries et le chargeur se produira probablement de provoquer un
incendie.
Use the included foam pads to secure the battery and prevent
shifting during running
Front or rear wire
openings allow you
to choose positioning
Position forward for more front traction
Position battery rearward for more rear traction
6
THIS VEHICLE DOES NOT HAVE A POWER SWITCH ALWAYS DISCONNECT THE BATTERIES BEFORE
TURNING OFF THE CONTROLLER AND WHEN THE
VEHICLE IS NOT IN USE
Turn on the transmitte .
1
r
Place vehicle on a stand or box to
help prevent accidental run-away
Firmly connect both ESC leads to one battery on each side of vehicle
2
Range-Checking Your Radio System
The radio system should be checked before operating the vehicle to ensure it’s operating properly and has adequate range.
1. Turn on the transmitter first and then the vehicle.
2. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
3. Walk away until you are at the farthest distance you plan to operate the vehicle.
4. Steer the vehicle back and forth and throttle both forward and reverse making sure there is no erratic behavior.
5. If any erratic behavior is exhibited do not operate the vehicle, call customer service for further assistance.
RANGE-CHECKING FOR DISTANCE
7
Steering trim setup
BIND
ST-TRIM TH-TRIM ST-D/R
Recommended motor: AE-4 Vanguard XL
8
See instructions
below
BIND
ST-TRIM TH-TRIM ST-D/R
91011
Loading...