Axial Racing AX24250 User Manual

AX24250 AE-1 Forward/Reverse ESC Instructions

Red

-

Battery

Black

+

Setup:

• Mount the ESC in an area that is well ventilated and isolated from vibration and shock.

• Connect the ESC wires to the motor.

• Plug the receiver wire into the throttle channel on the receiver.

• Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at zero

• Switch on the power of the ESC, make sure your radio is on

• The ESC will emit 3 beeps confirming the ESC is ready to work

• Apply throttle to make sure the motor is going the direction you wanted. To reverse the direction of the motor
switch the wires going to the motor. Do not reverse the battery wire connections! Reversing the battery

polarity will permanently damage the ESC.

CAUTION

Connect the battery pack just before driving and disconnect it immediately after.

Always make sure you are connecting the ESC to a proper power source that has the correct voltage & polarity.

Incorrect voltages or reversed polarity will damage the ESC.

Blue

-

Orange

+

Specifications:

On-Resistance-Forward FET

On-Resistance-Reverse FET

Rated/Peak Current-Forward

Rated/Peak Current-Reverse

Input Voltage

Size

Weig ht

Motor

Braking Current

BEC Voltage/A

PWM Frequency

Motor

5~10 Cell-2VDC/Cell

34.8 x 33.5 x 30mm

53g

15T or greater

0.0025Ω

0.005Ω

60A / 150A

35A / 75A

150 A

DC 5V / 1A

1 K Hertz

Once the battery pack is connected, handle the model with extreme care, make sure you are clear of all rotating parts.

AX24250-I001