Axiall Accu-Tab 3000, Accu-Tab 3012, Accu-Tab 3008C, Accu-Tab 3500, Accu-Tab 3530 Instruction Manual

DANGER:

DO NOT MIX CHEMICALS!

The Accu-Tab® chlorinators are designed
for use with Axiall approved tablets only.
Do not use Cal-Hypo tablets with
stabilized chlorine or bromine products, or
other sanitizing chemicals.
Fire or explosion could result.

Accu-Tab® System Chlorinators

by Axiall LLC

3000 Series Instruction Manual

Revised 06-25-15

1

Installation – Suction return – Pool Applications

The following installation instructions are for
Figure 1 only. Other installations are similar and may
require more or less equipment. (NOTE: Model 3500
CANNOT be installed in suction return applications.)

Using the existing circulation pump – Pump must have
vacuum on the suction side. – Figure 1.

1. Locate the chlorinator near the pump.

2. Turn off the pump and stop water flow in
preparation for cutting the pipe.

3. Install two pipe TEEs as shown in Fig. 1.

4. Install service valves on the supply and return
lines to isolate the chlorinator.

5. Using PVC pipe (or flex hose) and appropriate
fittings, including a control valve and flow meter,
connect the supply line to the chlorinator.

6. Connect the return line in the same manner.

7. Pipe sizes as follows:

3008C/3012 ¾” 1½”
3075 1” 2”
3150/3500 1½” 3”

8. Restart the pump, open the return service valve

9. Make sure the sieve plate is in its proper

10. Installation is now complete.

NOTE: For NSF Std 50 applications, an appropriately
sized control valve having a minimum of 4 positions and
a flow meter must be installed on the chlorinator inlet
supply line.

Model Inlet Outlet

FIRST, then open the supply service valve and
control valve to establish flow through the
chlorinator. Check for leaks.

position, resting in the groove.

Installation – Atmospheric Return

Figure 2. Include a return valve to allow easier

cleaning.

Installation – Pressure Return

Figure 3. Include a pump and check valve, Pump

should be capable of required water flow through the
chlorinator at the required system pressure. Models

3150 & 3500 require a 2” supply line.

2

Operation

To refill the chlorinator

1. Isolate the chlorinator. Important: Close the
supply valve BEFORE closing the return valve to
prevent over-pressurization of the chlorinator.

2. Open the vacuum relief valve (Models 3075 &

3150) to relieve vacuum.

3. Remove the lid. (Be careful not to inhale fumes.)

4. Fill the chlorinator with Axiall LLC Accu-Tab®
Tablets.

5. Replace the lid, making sure the surfaces are
clean and the O-ring is seated.
(Models 3008C, 3012, 3075 & 3150. Use
silicone based oil ONLY for lubrication.)

6. Close the vacuum relief valve.

7. Open the return valve first, then the supply valve.

To operate the chlorinator

1. Start flow through the chlorinator. Important:
Open the outlet valve BEFORE opening the inlet
valve to prevent over-pressurization of the
chlorinator.

2. Adjust the control valve to the desired setting.
Check Available Chlorine regularly to determine
the best setting.

3. Adjust the control valve and refill the chlorinator
as needed to maintain chlorine levels.

Note: When pool circulation stops, flow to the
chlorinator will stop. This will stop chlorine delivery.

Cleaning

The chlorinator should be cleaned twice per year to
remove any residual product that may accumulate inside
the unit. Cleaning may be accomplished by soaking in a
dilute acid solution. Addition of muriatic acid will lower
the pH of the water. Be prepared to add a suitable pH
increaser after cleaning is complete.

Preparation for cleaning:

1. Have 2 gallons (24 fl. oz. for 3008C & 3012) of
muriatic acid ready to add to the chlorinator.
Wear rubber gloves and rinse all equipment
thoroughly when finished.

2. Have a clean, empty container for storage of any
tablets inside the chlorinator.

3. Always use appropriate safety equipment while
servicing the chlorinator or handling chemicals.

To clean the chlorinator while installed:

1. Isolate the chlorinator from the system by
closing both the return and supply valves.

2. Remove the lid and remove all the tablets from
the chlorinator. Temporarily place these tablets
in the clean, empty container.

3. Rinse the chlorinator with water and (with the lid
removed) open the return valve temporarily to
drain the chlorinator.

4. Close the return valve and repeat step number 3.

5. Close the return valve and fill the chlorinator with
water so there is about one inch of water above
the sieve plate. Using rubber gloves and other
safety protection, carefully pour the muriatic acid
into the chlorinator including the walls of the
chlorinator. ALWAYS ADD ACID TO WATER,
NEVER ADD WATER TO ACID. Leave the lid
removed and do not breathe any fumes. Let
soak for 30 minutes.

6. After 30 minutes, open the return valve. Open
the supply valve and flush the chlorinator for 30
minutes at 10-20 gpm (5 gpm on Models 3008C
& 3012).

7. After 30 minutes of flushing, isolate the
chlorinator and rinse the walls with water. Drain
the chlorinator by temporarily opening the return
valve. Rinse a second time and drain.

8. For models 3008C and 3012, rinse off the tablet
canister and soak in muriatic acid to remove any
residue, making sure all the holes are open.
Rinse well with water when finished.

9. Cleaning is now complete.

3

4

5

6

SERIES 3000 LIMITED LIFETIME WARRANTY

Axiall LLC ("Axiall") warrants (subject to the below
conditions) the mechanical integrity of its Series 3000
chlorinators for the entire time the chlorinator remains in
its original installation. THIS IS THE ONLY
REPRESENTATION OR EXPRESS WARRANTY THAT
AXIALL MAKES AND ALL OTHER EXPRESS
WARRANTIES UNDER STATUTE OR ARISING
OTHERWISE IN LAW FROM A COURSE OF DEALING
OR USAGE OF TRADE WITH RESPECT TO THE
CHLORINATORS ARE DISCLAIMED. ANY IMPLIED
WARRANTIES EXISTING AS A MATTER OF LAW
SHALL NOT EXCEED THE DURATION OF THIS
LIMITED WARRANTY. IN THE EVENT A
CHLORINATOR FAILS TO CONFORM TO THIS
WARRANTY, AXIALL'S EXCLUSIVE OBLIGATION AND
YOUR EXCLUSIVE REMEDY SHALL BE LIMITED TO,
AT AXIALL'S OPTION, THE FURNISHING OF NEEDED
REPLACEMENT PARTS OR THE FURNISHING OF A
NEW CHLORINATOR (BUT THIS DOES NOT
INCLUDE INSTALLATION OR THE COSTS FOR
INSTALLATION). EXCEPT AS PROVIDED IN THE
IMMEDIATELY PRECEDING SENTENCE, IN NO
EVENT WILL PPG BE LIABLE UNDER ANY THEORY
OF RECOVERY (WHETHER BASED ON
NEGLIGENCE OF ANY KIND, STRICT LIABILITY OR
TORT) FOR ANY DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, PUNITIVE, OR CONSEQUENTIAL
DAMAGES IN ANY WAY RELATED TO ANY USE
MADE OF THE CHLORINATOR.

Warranty Conditions. This Limited Lifetime Warranty
shall apply and be effective only if:
(i) The Axiall Chlorinator Warranty Registration
information has been completed within thirty (30) days of
the customers receipt of the chlorinator via the Internet
at www.accu-tab.com under “Equipment Warranty”;
(ii) the chlorinator is installed and operated and
maintained in accordance with this manual and the
instructions accompanying the chlorinator;
(iii) only Axiall 's Accu-Tab® calcium hypochlorite tablets
are used in the Chlorinator. If any of these conditions
are not met, this Limited Lifetime Warranty will not apply
and you acknowledge and agree that your purchase of
the Chlorinator will be on an "AS-IS" basis without any
warranty of any kind whatsoever having been provided
by Axiall.

You assume all responsibility and risk and liability arising
from: (i) the unloading, installation, storage, handling
and use of the chlorinator, including use thereof alone or
in combination with other materials; (ii) the improper
functioning or failure of unloading, installation,
transportation or storage equipment you use, whether
furnished or recommended by Axiall or not; and, (iii) the
failure to comply with laws, rules and regulations
governing storage, unloading, installation, handling, and
use of the chlorinator. You will indemnify, hold
harmless, and defend Axiall from and against any claim,
suit, damage, cost, expense, fine, liability, or cause of
action whatsoever, including reasonable attorney fees,
on account of relating to, or arising out of the use,
possession, installation or resale of the chlorinator.

This Limited Lifetime Warranty gives you specific rights,
and you also may have other rights, which vary from
jurisdiction to jurisdiction. Some jurisdictions do not
allow the exclusion or limitation of incidental or
consequential damages, so the above limitations or
exclusions may not apply to you. Some jurisdictions do
not allow limitations on how long an implied warranty
lasts, so the above limitation may not apply to you.

To obtain service on this warranty, please contact the
distributor from whom you received your Accu-Tab®. If
for any reason you are not completely satisfied with the
results, write to:

Axiall LLC
Accu-Tab® Customer Service
11 Stanwix Street
Suite 1900
Pittsburgh, PA 15222
Phone [phone]
www.accu-tab.com