10 TECHNICAL DATA ............................................... 37
SAFETY
■
The following warning signs warn you of dangerous situations and their
severity:
ფ
ფ
ქ
ტ
DANGER!
WARNING!
CAUTION!
NOTE!
High risk, lethal hazards, severe injuries
Medium risk, severe injuries
Low risk, minor injuries
Damage to property
1.1 NORMAL USE
The AXENT shower toilet is a shower toilet with spray attachment for rear wash and front wash
cleaning functions. It can also be used as a normal WC seat at any time. Its use is limited exclusively
to enclosed spaces.
Any other usage will be deemed as not corresponding with normal usage. AXENT undertakes no
liability for abnormal usage.
1.2 IMPORTANT SAFEGUARDS
When using electrical products, especially when children are present, basic safety precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
DANGER!
ფ
To reduce the risk of electrocution
●
Always unplug this product immediately after using.
●
Do not use while bathing.
●
Do not place or store product where it can fall or be pulled into a tub or sink.
●
Do not place in or drop into water or other liquid.
●
Do not reach for a product that has fallen into water. Unplug immediately.
3
SAFETY
WARNING!
ფ
To reduce the risk of burns, electrocution, fire, or injury to persons
●
Close supervision is necessary when this product is used by, on, or near children or invalids.
●
Use this product only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
●
Never operate this product if it has a damaged cord or plug, if it is not working properly, if
it has been dropped or damaged, or dropped into water. Return the product to a service
center for examination and repair.
●
Keep the cord away from heated surfaces.
●
Never block the air openings of the product or place it on a soft surface, such as a bed or
couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and
the like.
●
Never use while sleeping or drowsy.
●
Never drop or insert any object into any opening or hose.
●
Do not use outdoors or operate where aerosol (spray) products are being used or where
oxygen is being administered.
●
Connect this product to a properly grounded outlet only. See Chapter 1.4.
●
Unplug this product before filling. Fill (reservoir) with water only unless otherwise specified
by manufacturer. Do not overfill (or specify filling instructions).
SAVE THESE INSTRUCTIONS
1.3 SAFETY INSTRUCTIONS
Carefully read and observe the following safety instructions!
Information for the user
●
Children and persons with insufficient knowledge or experience in handling the device, or who
have limited physical, sensory or mental capabilities, may only use the device following proper
instruction or when supervised.
●
Make sure that children cannot play with AXENT shower toilet.
Avoid malfunctions and damage to the product as a result of improper use.
●
If AXENT shower toilet is moved from a cold location to a warm loc ation, condensation may form.
Leave the unit switched off for a few hours.
●
Do not install AXENT shower toilet in rooms where there is a danger of frost. The room
temperature must not be less than 39 °F (4°C).
●
Do not place open fire sources, candles, cigarettes, or similar, on AXENT shower toilet.
●
Do not reuse the old hose-set. Please use the new one only.
4
SAFETY
●
Do not expose the AXENT shower toilet directly to water.
●
Do not climb on or stand on the product.
●
Do not place any heavy objects on the lid.
●
Only open the seat and cover via the remote control.
●
Do not push the lid down with excessive force.
●
Do not deliberately soil, spray or block the spray arm.
Repairs must only be carried out by a person with the necessary expertise
●
Do not carry out modifications, tamper with, install additional equipment or attempt to repair the
AXENT shower toilet.
●
Improperly performed repairs can lead to accidents, damage and malfunctions.
Only use the device when it is fully functional
●
Make sure that the power cable or mains plug is not damaged.
●
The power cable must not become jammed or pinched.
●
Keep the power cable away from hot surfaces and sharp edges.
●
Never touch the mains plug with wet hands.
●
Do not use the product if it is not working properly.
Disconnect it from the mains immediately. Close the water cut-off valve to interrupt the water
supply. Contact your installer.
Information on the use of batteries
●
Keep batteries out of the reach of small children. Batteries can be life-threatening if swallowed. If
a battery has been swallowed, call for medical assistance immediately.
●
Batteries may not be recharged, reactivated by other means, dismantled, exposed to fire or
short-circuited.
●
Always remove empty batteries from the remote control immediately. They may leak and cause
damage.
●
Do not insert new and old batteries together in the remote control.
●
Clean the battery and contacts before inserting the battery. Note the proper polarity.
●
Remove the batteries if you do not use the remote control for an extended period.
●
Do not expose the batteries to extreme conditions: avoid contact with hot surfaces or direct
sunlight. Otherwise there is a risk of leakage.
●
If battery acid has leaked, avoid contact with skin, eyes and mucous membranes. In case of
contact with the acid, flush the affected areas with large amounts of clean water and consult a
doctor immediately.
5
SAFETY
Grounding pin
Grounded outlet
Grounded outlet box
1.4 GROUNDING INSTRUCTIONS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for the electric current.
This product is equipped with a cord having a grounding wire with a grounding plug.
The plug must be plugged into an outlet that is properly installed and grounded.
DANGER!
ფ
Improper use of grounding plug can result in a risk of electric shock
●
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire
to either flat blade terminal. The wire with insulation having an outer surface that is green
with or without yellow stripes is the grounding wire.
●
This product is factory equipped with a specific electric cord and plug to permit connection
to a proper electric circuit. Make sure that the product is connected to an outlet having the
same configuration as the plug. No adapter should be used with this product. Do not modify
the plug provided — if it will not fit the outlet, have the proper outlet installed by a qualified
electrician. If the product must be reconnected for use on a different type of electric circuit,
the reconnection should be made by qualified service personnel.
●
If it is necessary to use an extension cord, use only a three wire extension cord that has
a three-blade grounding plug, and a three-slot receptacle that will accept the plug on the
product. Replace or repair a damaged cord.
Wiring Diagram (NOT FOR INSPECTOR’S U SE)
NOTE!
ტ
●
Actual field installation maybe be slightly different from diagram. Provided fittings will be
connected at the bottom of unit instead on the sides.
6
SAFETY
1.5 FCC INSTRUCTIONS
Please note that changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
–
Reorient or relocate the receiving antenna.
–
Increase the separation between the equipment and receiver.
–
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
–
Consult the dealer or an experienced radio/TV technician for help.
7
■
This manual is applicable for the following products:
ს
[E322-02]
PRODUCTS
PRODUCTS
9
Loading...
+ 31 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.