AVTECH LT-32-ADP User Manual

Light Tower & Relay Adapter (RMA-LTA-SEN)

Installation Note

AVTECH’s Light Tower & Relay Adapter (LTA) expands the capacity of your Room Alert
monitor. With it, you gain a built-in relay port to control 1 electrical appliance and a custom port
to connect and control:

• 1 AVTECH Relay Switch Sensor

+ 3 electrical appliances
+ 1 general alarm to Room Alert or alarm panel

OR

• 1 AVTECH Light Tower (any model)

Sample Light Tower & Relay Adapter product configurations are shown below.

OR

Appliance

Connected To

Relay Port

Light Tower (Any Model)

OR

Relay Switch Sensor

(Connecting Other Appliances)

With Room Alert’s web interface or AVTECH’s Device ManageR software, you may
automatically or manually turn on & off electrical devices—such as the ones shown here—and a
Light Tower’s individual LEDs and audio alarm (if available).

For more information about AVTECH’s Light Towers and/or Relay Switch Sensor, please see
their Installation Notes, visit AVTECH.com or contact a Product Specialist.

AVTECH Software, Inc.

Temperature & Environment Monitoring… Made Easy!

AVTECH.com

Light Tower & Relay Adapter (RMA-LTA-SEN)

Light Tower & Relay Adapter Package Contents

• One (1) Light Tower & Relay Adapter ID Box

• One (1) 25' RJ-11 Cord

• One (1) AVTECH International Power Adapter

• One (1) Installation Note (You’re reading it now.)

The Light Tower & Relay Adapter ID Box

Left Side

Digital Port Power Port

Relay Port Custom Port

Front

Install Your Light Tower & Relay Adapter

Do not use the Light Tower & Relay Adapter (LTA) in hazardous (classified)
locations or life/safety applications.

Step 1: Connect your Light Tower & Relay Adapter to your Room Alert monitor.

Your Light Tower & Relay Adapter comes with a 25' RJ-11 cable.

1. Connect one end of the RJ-11 cable to the digital port on the Light Tower & Relay

Adapter ID box.

2. Connect the other end to the Light Tower/Relay Switch port on the compatible Room

Alert ID box or digital port on the Room Alert 3E model.

Step 2: Connect your Light Tower & Relay Adapter to a power source.

Your Light Tower & Relay Adapter comes with AVTECH’s International Power Adapter.

1. First connect AVTECH’s International Power Adapter to the power port on the Light

Tower & Relay Adapter.

2. Then plug it into a power source.

Use only AVTECH’s International Power Adapter with AVTECH monitors and
sensors; others could damage your product and will void the warranty.

AVTECH Software, Inc. Page 2 of 5 AVTECH.com