AVSL VGW1 User Manual

VGW1

VHF Guitar Wireless System

Item ref: 171.848UK

User Manual

Version 1.3

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

171.848UK User Manual

Introduction:

Thank you for choosing the Chord VHF-series wireless system. This professional wireless set provides an instrument VHF
radio system for freedom of movement without loss of audio quality. Please read this manual before using this equipment
in order to avoid damage through incorrect operation and to get the best performance from your purchase.

Contents:

Please take care when unpacking this product. Inspect for any damage and ensure you have the following components…

• VHF wireless receiver

• Mains power adapter

• 6.3mm to 3.5mm instrument jack lead

• 6.3mm mono jack lead

• 9V battery, PP3

Warning:

To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by qualified
personnel before further use.
Avoid impact or heavy vibration to any of the components.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.

Safety

• Ensure that the correct adapter is used with adequate current rating and that the mains voltage is as stated on the

adapter.

• Avoid ingress of water or particles into the transmitter(s) or receiver

• Use alkaline or NiMH batteries in the transmitter(s) and remove if unused for long periods.

• Observe the correct polarity when replacing batteries

Placement

• Keep all components out of direct sunlight and away from heat sources.

• Do not place heavy objects on top of the receiver or transmitter(s)

• If rack-mounting, secure the receiver to a 1U rack tray and do not place heavy equipment above the receiver.

• Keep the transmitter(s) and receiver away from damp or dusty environments.

Cleaning

• Use a soft cloth with a neutral detergent to clean the body of the beltpack transmitter and receiver.

• Lightly damp sterile wipes may be used on the beltpack for hygiene purposes

• To avoid damage, do not use solvents to clean the components