AVSL STP-2 User Manual

STP-2

Item ref: 128.513UK

Stereo Phono Preamplifier

User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Power supply

9Vdc, 100mA (or optional PP3 battery)

Equalization

RIAA correction

Frequency response

30Hz - 20kHz

Gain

34dB

Input impedance

50k ohms

Output impedance

50k ohms

Dimensions

30 x 70 x 90mm

Weight

250g

Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.

The goods must be disposed of according to your local council guidelines.

Introduction

Thank you for choosing the STP-2 stereo phono preamplifier as part of your audio system.
This unit has been designed to allow vinyl turntables to be connected to line level or
auxiliary inputs, whilst delivering the best sound quality possible.

Setup and Connection

 Ensure turntable is fitted with a magnetic cartridge
 Connect phono outputs from the turntable to the inputs (1)

of the STP-2 via good quality RCA leads

 Connect the outputs (4) from the STP-2 to the line or

auxiliary inputs of the mixer or amplifier

 Connect the supplied 9V power adaptor to the DC jack (3)

and move the slide switch (2) to “ON”

 The STP-2 will now boost the turntable output from phono

to line level

 The front of the STP-2 can pivot open to reveal the battery

compartment allowing a PP3 battery to be used if preferred

Specifications

Errors and omissions excepted.

Copyright© 2014. AVSL Group Ltd.