AVSL SLIMLINE FIXED WALL BRACKETS User Manual

SLIMLINE FIXED WALL BRACKET MANUAL

www.av-link.co.uk Order Ref: 129.353UN

NOTE: Please read and follow these installation instructions carefully, and always work within the guidelines of your

screen manufacturer. Assembly and fitting should be performed by a capable installer at their own risk.
We are not liable for any damage caused by improper installation.

IMPORTANT!

• For safety reasons, the wall or mounting surface must be capable of supporting the combined weight of the mount and
the display; otherwise the structure must be reinforced.

• Safety gear and proper tools must be used. Failure to do so can result in property damage and/or serious injury.

• Make sure that no electrical cables, water pipes or gas pipes are located within the wall.

Tools required for the installation:

• Phillips Head Screw Driver

• Electric or Portable Drill

Also make sure that all of the hardware has been included with your bracket.You should find the following:

(A) M8x63 Lag Bolt X 2 (B) Concrete Anchor X 2 (C) Lag Bolt Washer X 2

(D) Small Spacer X 4 (E) Large Spacer X 4 (F) M6 Washer X 4

(G) M4x12 Bolt X 4 (H) M4x30 Bolt X 4 (I) M4 Lock Washer X 4

(J) M5x12 Bolt X 4 (K) M5x30 Bolt X 4 (L) M5 Lock Washer X 4

• 1/4” (6 mm) Drill Bit + Stud Finder ( Drywall Installation )

• 7/16” (11 mm) Masonry Bit ( Concrete Installation )

• Ratchet Driver with 1/2” (13 mm) Socket • Spirit Level

(M) M6x12 Bolt X 4 (N) M6x35 Bolt X 4 (O) M6 Lock Washer X 4

(P) M8x16 Bolt X 4 (Q) M8x40 Bolt X 4 (R) M8 Lock Washer X 4

Installing the bracket

Drywall Installation

Center of the stud

1a

Stud Finder Tape Measure Tape Measure

Concrete/Brick Installation

1b

2a

Use a pen to mark the holes Use a pen to

2b

Continues on the next page Continues on the next page

mark the holes

SLIMLINE FIXED WALL BRACKET MANUAL

www.av-link.co.uk Order Ref: 129.353UN

3a

4a

Use the correct shorter bolts / Lock washers / Washers

++

3b

Insert one Concrete Anchor (B)
into each hole.

4b

Fix the wallplate to the wall
using the Lag Bolt (A) provided.

Displays with flat backs.

5 6

Displays with curved
or recessed backs.

+ ++

Use the correct longer bolts / Lock washers / Washers / Spacers

7

Displays with flat backs.

Displays with curved
or recessed backs.

Do not use the M6 Washers (F) if you are using the M8 Bolts (P or Q).

A small padlock can be used to
help prevent theft of your display.

NOTE: Padlock not included