AVSL SL4-RC User Manual

SL4-RC

Item ref: 153.811UK

RGB LED STRIP CONTROLLER

User Manual

WARNING: This product operates at high voltage and is for professional use ONLY!
Installation should be performed only by fully qualified personnel.

INCLUDED: 4-pin Coupler, Heat-shrink Tubing (153.815UK), End Cap (153.819UK)
For water-tight bonds, silicone glue (153.627UK not supplied) is recommended.

IMPORTANT: Maximum RGB strip length for SL4-RC controller is 25m total.
Do not connect longer runs as this will damage the controller.
Please do not connect any part to the mains until steps 1-4 have been completed.

ASSEMBLY

1) Roll out the LED Strip from the reel and cut to size only at the clearly marked

scissor points. Ensuring you use a sharp cutting knife or scissors. (Max. 25m)

2) Use the supplied end cap to terminate the open end of the strip by filling the

end cap ½ way with silicone glue and pushing firmly on the end of the strip.
Wipe excess glue away and leave to dry for 10 minutes.

3) If the strip is to be extended onto another strip or fitted around tight

corners, it will be necessary to use a strip coupler (153.817UK) or flexible
link (153.818UK). For either of these options, create the connection in the
same manner as described below for the RGB controller connection.

153.811UK User Manual