Page 1
RP4
4-Channel DMX Relay Pack
Item ref: 154.111UK
User Manual
Page 2
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
1.
IEC Power outputs (2 x IEC per channel)
2.
Power on/off switch
3.
DMX input XLRM
4.
DMX loop output XLRF
5.
Channel fuses
6.
AC power inlet
7.
DIP switch settings
The RP4 4 channel DMX relay pack has 4 DMX channels each with 2 IEC power outputs per channel. It
completely turns the power on and off saving energy and preserving the lifespan of your light effects. This is
ideal for use with LED light effects, which when used with traditional dimmer packs turn on and off randomly
with the pulsed voltage sent through the system.
Features
4 DMX channel output
Power ON/OFF for each channel
DIP switch DMX addressing
Wall mountable
Warning before use
This item is for Professional use only. Please take note of the following instructions before using this device.
• This unit must be earthed.
• Do not turn on the power until all connections are securely made.
• Always disconnect from the mains before replacing any fuse
• There are no user serviceable parts inside
Fuses
The RP4 can carry maximum overall load of 10 amps. Each channel can also carry a maximum overall load of 10 amps
but the unit is factory fitted with 10amps on each channel. These can be changed but the maximum overall load and
each channel load must not exceed 10 amps. You must be professionally qualified in order to carry this out.
Layout
154.111UK User Manual
Page 3
Operation
DIP switch ON
Setting
10
DMX control - Set start address using DIP switches 1- 9
1
Channel 1 ON
DIP switch 10 is OFF
2
Channel 2 ON
3
Channel 3 ON
4
Channel 4 ON
Power supply
230Vac, 50Hz
Power outlets
4 x 2 x IEC
DMX Channels
4
Dimensions
193 x 72 x 260mm
Weight
2.5kg
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
DIP Switch settings
The RP4 can be used as a 4 Channel DMX switch pack or for standalone operation:
Stand alone: Set DIP switch 10 to OFF then use switch 1 to 4 to turn on / turn off each channel
DMX Mode: Set DIP switch 10 to ON and use DIP switches 1 - 9 to set the DMX start address.
In DMX mode, 4 channels (starting at the selected start address) can be used to turn on or turn off each channel by
adjusting the slider accordingly (000/0% = OFF, 255/100% = ON)
Specifications
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.
154.111UK User Manual
Loading...