Page 1
Power Supply
Pole Mount Bracket
NAUHF-A38
NAUHF-A38
4G READY ACTIVE NOTCH TV
Item ref: 130.002UK
User Manual
AERIAL
Page 2
INTRODUCTION:
Thank you for choosing Mercury antenna. This is a new concept antenna based on current mobile
communication technology. Anti-UV and water proof casing make it ideal for outdoor installation. It is
specially designed for the purpose of analogue and digital TV reception, with a built in 4G filter, so that
you will never have to worry about interference from the 4G mobile signal. The design of this aerial is
much more compact compare to a traditional aerial of the same gain; this is due to the built in, low noise,
high gain amplifier, making it possible. Ready to install from the box, which will save a considerable
amount of installation time and labour cost. Well-designed outer case will greatly improve the appearance
of an aerial installation.
SPECIFICATION:
Frequency Range : 470-790MHz
Antenna Gain: 38dB
Maximum Output Level: 100dBµV
Impedence: 75Ω
Noise Figure: ≤3.5dB
Power Supply: 12Vdc 50mA
INSTALLATION:
- Using the bracket to clamp the aerial to the pole mast.
- Antenna can also be mounted directly to the wall horizontally or vertically. Simply take the wall
bracket off from the back of the antenna, screw bracket onto the wall facing closest to the
transmission tower, and screw the antenna back on to the bracket.
Page 3
- For installation in a flat or apartment, it is also possible to mount the aerial directly on to a
balcony. Please ensure antenna is facing outside.
CONNECTION:
Ensure both power supply and TV are switched off and unplugged. Connect the antenna port of the
power supply to the antenna by F plug coax cable, use the water proof boot supplied to cover the
connection. Then connect the TV port of the power supply to set top TV receiver, for TV with digital
TV ready, it can be plugged into the TV directly.
Page 4
After finishing mounting the antenna, adjust the position of the antenna until the best picture and
sound quality is achieved (Usually facing the direction of the transmitting tower). Antenna mount is
designed to be turned 45° to left and right for easy positioning. Fix the antenna at its best receiving
position by tighten the fix position nut at the bottom of the mount. Cable management can then be
performed to improve overall appearance and avoid tripping over. Extra safety wire can be installed
through the pre-drilled hole as indicated below to prevent falling in case of bracket failure.
Please note, for best reception. Position antenna at the highest possible location, as blockage in line of
sight between antenna and transmission tower may cause signal loss, having the antenna installed at
highest possible location will minimize the chance of signal blockage.
This product is classed as Electrical or Electronic equipment and should not be disposed
with other household or commercial waste at the end of its useful life. The goods must be disposed of
according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd
Loading...