AVSL MSPL03 User Manual

MSPL03

WIDEBAND MASTHEAD SIGNAL

Item ref: 130.050UK

User Manual

SPLITTER

SPECIFICATION:

Frequency range: 5 - 2400MHz
Insertion loss: 6.5 – 9.5dB
Return loss: 10dB
Isolation: 20dB
DC power pass (Max): 24V/200mA
Dimensions & weight: 110 x 80 x 45mm, 130g

INTRODUCTION:

Thank you for choosing this Mercury masthead splitter. It is designed to be installed after a masthead
amplifier or after a satellite LNB to allow distribution of TV or satellite signals. Supplied in IP44 rated
casing for outdoor installation.

- F-type connector for secure connection.

- Fully shielded for minimum signal interference.

- DC pass allows power for LNB or masthead amplifier.

- Wideband frequency response compatible with FM/DAB/DTV(DVB-T, ATSC, ISDB-T, T-

DMB)/satellite.

INSTALLATION:

Before installing, to avoid danger of electric shock, please ensure that all equipment is turned off and
disconnected from the mains supply.
For TV signal connect the output of the masthead amp to the input of the splitter, and the output of
the splitter to various designated receivers and TV. Please note, only one power supply will be
required to connect to the output of splitter to power the masthead amplifier.

For satellite signal distribution:

After all cables have been attached, please use the supplied cable tie to secure the splitter.

This product is classed as Electrical or Electronic equipment and should not be disposed

with other household or commercial waste at the end of its useful life. The goods must be disposed of

according to your local council guidelines.

Errors and omissions excepted.

Copyright© 2014. AVSL Group Ltd

130.050UK User Manual