AVSL MINI BLACK LIGHT User Manual [en, de, fr]

LAMP WITH BUILT-IN BLACK LIGHT

PROJECTOR

160.120 / 160.122 / 160.124

Instruction Manual

Gebruiksaanwijzing

Mode d’Emploi

Gebrauchsanleitung

UK

Thank you for purchasing this SkyTec Pre-programmed rope light. Please read this manual carefully before
use and keep it for future use.

Safety Instructions

- Read the manual prior to use.

- Keep the manual for future reference.

- Keep the packaging so that you can transport the unit in its original packaging in order to avoid
damage.

- For indoor use only.

- When mounting the unit, leave enough spaces for ventilation.

- Do not use the unit close to heat sources or when exposed to direct sun light.

- Make sure that no liquids or small components can enter the housing.

- Use a damp, dust-free cloth to clean the unit. Do not use cleaners or solvents!

- The unit doesn’t contain user serviceable parts.

- Keep out of the reach of children.

- The unit should only be repaired by a SkyTronic approved repair service.

Installation and Operation

- This light effect needs to be powered by 4 AA cells. Do not use a combination of old and new
batteries.

- Make sure the batteries are correctly installed as indicated in the battery compartment.

- Switch this unit on with the power switch, the tl-bar will light up.

Replacing the lamp

When replacing the lamp, be sure that the lamp has cooled and the AA-cells are removed from the unit.
Remove the the top of the housing and gently turn the tl-bar counter clockwise to remove it. Insert a new tl­bar and gently turn it clockwise to install. Now replace the top of the housing, replace the AA-cells and turn
the unit on.

Cleansing

The most important part of your lighteffect to keep clean is the tl-bar as this allows the light output to be
transmitted. This should be cleaned with a soft damp cloth. The body of the unit may also be cleaned in the
same way. We recommend internal cleaning be carried out by a fully qualified technician.

Troubleshooting

- When the unit doesn’t work; check if the four AA-batteries are properly housed and fully charged.

- When the tl-bar doesn’t work at first time use; please check if the bar is correctly fitted, because
shipping might cause the tl-bar to loosen.

- When the unit is turned in “on-mode” and the tl-bar won’t light up; the tl-bar may require replacing.

Specifications

Power supply: ................................................................................................6 VDC (4 x AA-cells)

Dimensions: ....................................................................................................... 55 x 23 x 160 mm

• Specifications and design subject to change without prior notice

Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This woul d
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. SkyTronic UK cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.