AVSL MBM-1 MIRROR BALL MOTOR User Manual

MBM-1

Item ref: 153.106UK

Battery Powered Mirror Ball
Motor

User Manual

Introduction

Thank you for choosing the QTX MBM-1 battery powered mirror ball motor.

This item will provide a convenient solution for small to medium tasks where no mains power is available.
Please read the below instructions to ensure proper implementation and avoid damage through misuse.

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Battery

1.5V (1 x D) not supplied

Max. weight load

2kg

Rotation per minute

6rpm

Dimensions

180 x 50mmØ

Weight

130g

Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.

The goods must be disposed of according to your local council guidelines.

General safety

The MBM-1 is intended for indoor use only. Keep away from damp or humid environments.
Keep the motor and housing dust free and do not allow particles to enter the mechanism.

Clean the MBM-1 periodically with a dry, lint free cloth. Do not use solvents on the casing.

Keep away from heat sources or direct sunlight.

Installation

The MBM-1 mirror ball motor is powered by a single 1.5V cell (D type) which should be installed before
installation. Open the battery compartment and connect the D cell, ensuring the correct polarity as
indicated.Positioning of the mirror ball motor is very important. Safety is the most important factor. Please
note the following to avoid failure and possible injury…



The motor and mirror ball should be out of reach to avoid tampering



The mirror ball should not weight more than 2kg



The chain holding the mirror ball should be adequate for the load



The fixing into the ceiling must be strong enough to hold both mirror ball and motor



Operation

To start the motor rotation, slide the side-mounted switch to the on position. The spindle will rotate and
so the mirror ball will rotate also. The MBM-1 is hinged to allow some sideways movement if the load is
not perfectly symmetrical. Remember to switch off when not needed to preserve the battery. If not being
used for long periods, remove the battery and store in a dry place.

Errors and omissions excepted.

Copyright© 2013. AVSL Group Ltd.

153.106UK User Manual