AVSL MAM02 User Manual

MAM02

4G READY UHF MASTHEAD

Item ref: 130.040UK

User Manual

AMPLIFIER 2 OUTPUTS

SPECIFICATION:

Power: 12Vdc, 50mA
Frequency range: 470 – 790MHz
Gain: 25dB
Noise: <3.8dB
Impedance: 75Ω
Max output level: 94dBuV
Dimensions & weight: 110 x 105 x 52mm, 180g

INTRODUCTION:

Thank you for choosing this Mercury masthead amplifier. It is designed to amplify weak TV signal
from aerial. Supplied in an IP44 rated casing for outdoor installation.

- F-type connector for secure connection.

- Integrated LTE signal filter avoids interference and channel loss from 4G mobile signals.

- Fully shielded design for minimum signal interference.

- Maximum output limiter prevents overloading the receiver unit.

- Compatible with both analogue and digital TV reception (DVB-T, ISDB-T, DMB-T, ATSC)

INSTALLATION:

Before installing, to avoid danger of electric shock, please ensure that all equipment is turned off and
disconnected from the mains supply. This amplifier requires 12Vdc power to operate, the output of
the amplifier needs to be connected to masthead amplifier power supply (130.060UK or 130.061UK)
or to a TV receiver that has 12Vdc power supply on its input.

1. Open the outer casing by pressing the two latches on the side and lift up the cover to

reveal the amplifier.

2. Connect the aerial to input of the amplifier.

3. Connect the output1 of the amplifier to masthead power supply or TV receiver, and

output 2 to secondary TV set or distribution amplifier for further signal distribution.

4. Place the coax lead in the pre-cut groove and close the outer casing lid. Use the cable

tie supplied to secure the amplifier to the mast.

This product is classed as Electrical or Electronic equipment and should not be disposed

with other household or commercial waste at the end of its useful life. The goods must be disposed of

according to your local council guidelines.

Errors and omissions excepted.

Copyright© 2014. AVSL Group Ltd

130.040UK User Manual