AVSL MAGIC EYE User Manual

Magic eye
TV2

Coaxial cable

TV1

RF2

Satellite
decoder

IR

Sky
Remote

MAGICEYE Item ref:124.157UK

Magic eye with IR with coaxial lead User Manual

DESCRPTION:

Magic eye Digital Link will allow control of your SKY Digital satellite receiver
whilst viewing in other rooms around the home. This unit is compatible with UK
digital satellite receivers with an output marked RF-OUT2 that provides a second
TV output together with a 9V DC supply.

INSTALLATION:

Use only good quality cable for installation and avoid sharp bends or install near
mains cable. For installation together with amplifier, splitter or isolated outlet
plate please refer back to dealer for advice.

1. Unplug both TV and Decoder from the mains.

2. Plug the Magic eye’s coaxial lead into the aerial socket of the TV.

3. Connect Decoder’s RF2 outlet to Magic eye’s input socket using male to

male IEC connector Coaxial cable.

4. Plug in the mains for both TV and Decoder, switch both devices on.

5. Red light on the Magic eye should be on, place the IR receiver where it

will be seen by the remote. (Usually on top or by side of the TV).

6. You Magic eye is ready to use.

Note: If Magic eye is not in function at the end of the installation, please refer to
Satellite Decoder manual on how to activate RF2 output. For tuning satellite
channel please refer to your TV Manual.

Spec:

Input Signal Frequency 38kHz Carrier (lnfra Red System)
Output Signal Frequency On-Off Keyed 6MHz Carrier
Line power Requirement 9V DC @15mA
Infra Red Sensor Lead 0.9m
Output Connector IEC Male
lnput Connector IEC Female
Operating Temperature 0°C to +40°C

Errors and omissions excepted.

Copyright© 2013. AVSL Group Ltd.