Page 1
EPS Series
Electric Projector Screen
Item refs: 952.321UK/952.322UK/952.323UK/952.324UK/952.325UK
User Manual
Thank you for choosing this AV:Link electric projector screen. This large format projector screen has
a built-in electric motor controlled via the in-line switch or remote control. The screen is housed in a
white steel case with mounting brackets on either end, allowing installation onto ceilings or walls.
The screen itself has a weighted bottom bar to prevent the screen jamming in the case or curling.
Installation:
Before installation please ensure a mains socket is available within 1.5m distance of where the inline
controller is going to be installed and ensure the unit is not plugged in during the process of
installation.
This electric projector screen is suitable for both wall or ceiling mounting, it is important the unit is
installed accurately using a spirit level to ensure the screen can operate correctly & safely.
Please do not open cover, contain high voltage.
This product is not serviceable or repairable by end user.
Please contact approved professional in case
product fails to operate.
CAUTION
Please read through this manual carefully before use. This product is strictly for indoor
use only, please install this product in dry and cool environment and keep out of moist
and source of heat
Page 2
EPS Series User Manual
Screen position adjustment:
All electric projector screens will be pre-adjusted. If adjustment is required, the switch is located at
the right hand side of the projector screen on the end cap. A Philips tip screwdriver will be required
for adjustment. Please do not forcibly pull down the screen. Two separate switches set the open and
close positions by turning the adjustment screw within, the open and closed stop positions can be
adjusted.
Control:
This projector screen is supplied with an in-line controller and a remote control to operate the
screen:
Maintenance:
Maintenance and service of the unit should not be required throughout the duty life of the product.
We recommend dusting the unit on regular basis using a dry microfibre cloth. Use a slightly damp
microfibre cloth to remove any stains with max 5% soap solution. Always ensure the surface is
completely dry before closing the screen.
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at the
end of its useful life. The goods must be disposed of according to your local council guidelines
Errors and omissions excepted.
Copyright© 2014. AVSL Group Ltd.
Loading...