Page 1
sketch map(G)
tapping screw to fix the top cover
to the frame.
Use the M5*10 Phillips pan head
flush latch into the panels.
to the inside top of the frame.
the bottom of the side panels
/back panel,and install the
Fix the bottom brackets onto
sketch map(F)
tapping screw to fix the fan unit
Use the M5*10 Phillips pan head
sketch map(H)
supporting brackets to the mounting
rails.
angle ,and then fix the L shaped
mounting rail to the mounting
screw and flange nut to fix the
sketch map(E)
frame.
Use the hexagonal soket B head
panel to the inside bottom of the
tapping screw to fix the bottom
Use the M5*10 Phillips pan head
sketch map(D)
tray to bottom of the frame.
tapping screw to fix the caster
Use the M5*10 Phillips pan head
sketch map(C)
mounting angles to the frame.
sketch map(B)
tapping screw to fix the other
Use the M5*10 Phillips pan head
mounting angle to the frame.
screw and frange nut to fix the
Use the M5*10 Phillips pan head
sketch map(A)
TE cabinet assembly instructions(600 wide)
sketch map(H)sketch map(I)
sketch map(I)
sure the top of the door match up with the
frame.
door upright and release the top latch. Make
in the bottom of the frame,and then carefullly
place the door onto the door pivot pin. Pull
down the latch at the top of the door.Set the
Place the door pivot pin into the mounting hole
sketch map(G)
sketch map(F)
sketch map(A)
sketch map(B)
sketch map(C)
sketch map(E)
sketch map(D)
Loading...