AUDIO/VIDEO
Selector
YRM-714A
USER MANUAL V1.0
YRM-714A
Package Contents-
1 AVLINK YRM-714A
1 user manual
1 power adapter DC 12V/600mA
1 IR remote controller
2 rack rails, 8 screws
If anything is missing, please contact your vendor.
Features
Bandwidth 250MHz (-3db).
Compliant with the component RCA Video.
Supports 480p, 576i, 576p, 720p, 1080i.
Compliant with the RCA Audio.
Supports digital optical audio.
Remote controller for operation.
1U rack design.
Specifications
Function YRM-714A
Video Input 4 set RCA Connector
Video Output 1 set RCA Connector
Audio Input
Audio Output
LEDs
Select Switch 4
Power Adapter (Min.) DC 12V 600mA
Dimensions (LxWxH) 269x108x42mm
On Line 4
Selected 4
Housing Metal
Weight 1090g
FRONT VIEW
1. Push-button Switches (Manual type)
2. Port LEDs
3. IR Receiver
4 Digital Optical TOSlink
4 set (R,L) RCA Connector
1 Digital Optical TOSlink
1 set (R,L) RCA Connector
-1-
REAR VIEW
1. Power Jack
2. Video Input
3. Stereo Unbalanced Audio Input
4. Digital Optical Audio Input
5. Video Output
6. Stereo Unbalanced Audio Output
7. Digital Optical Audio Output
Installation
Before the installation, make sure the peripherals of all
DVD’s are grounded properly and turned off.
1. Connect the YRM-714A video input RCA connector with
the RCA Video male to male cable from the DVD
players.
2. Connect the YRM-714A audio input RCA connector with
RCA audio cable from DVD
3. Connect the YRM-714A video output RCA connector
with the RCA Video male to male cable from HDTV.
4. Connect the YRM-714A audio output RCA connector
with the RCA audio cable from HDTV or the audio
amplifier
5. Connect the power adapter on each side.
6. The red LEDs will flash back and forth. If not, please go
back to check step 5.
7. Turn on the DVD
amplifier.
8. The green on line LED flashes while the DVD player
has been connected in proper order with the
corresponding port & is running.
players.
players and HDTV and the audio
-2-
Operation
1. Port selection
Press the button of “port selection switch” to access
the desired DVD player.
The selected corresponding port will light on for the
red LED’s which indicate that the port is activated.
2. IR remote control
Use the “1”, ”2”, “3”, ”4” keys to select DVD player
that desired DVD player.
Use the “
Use ”SCAN MODE” key to enable/disable the Auto
Scan function:
Auto Scan time can be increased progressively from
every 5 seconds to 30 seconds by using the “▲” key.
Conversely, use the “▼” key to decrease the time from
30 seconds to 5 seconds.
While the Auto Scan function is applied, the port
selection keys will not work.
© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.
Trademarks:
All the companies, brand names, and product names
referred to in this manual are the trademarks or
registered trademarks belonging to their respective
companies.
”, “▼” keys to select another DVD player.
▲
-3-
Loading...