Avlink VRM-1714 User Manual
Multi-Sync
Video Selector
Features
Bandwidth 250MHZ (-3db).
Support VGA, SVGA, UXGA, QXGA resolutions.
Support Multi-Sync video type include RGBHV, RGsB,
RGBS.
Support synchronous Include positive, negative; TTL or
1Vpp level.
Supports the DDC1, DDC2, DDC2B, DDC2B+,
DDC2AB. (For video out port 1)
Specifications
FRONT VIEW
VRM-1712
VRM-1714
USER MANUAL
VRM-1712
VRM-1714
Package Contents-
1 AVLINK VRM-1712 or VRM-1714 Multi-Sync Video
Selector
1 user manual
1 power adapter DC 9V/600mA
If anything is missing, please contact your vendor.
Function VRM-1712 VRM-1714
VGA Input Conne ctor
VGA Output Connector 1x HD-15 Female
LEDs
Select Switch 2 4
Max. Resolution 2048x1536 60Hz
Power Adapt er (Min.) DC 9V 600mA
Dimensions (LxWxH) 128x75x45 mm
On Line 2 4
Selected 2 4
Housing Metal
Weight 400 g 420 g
2x HD-15
Female
Technical Specifications
Input/Output Signal
Pin # Signal
1 Red video 9 NC
2 Green video 10 Ground
3 Blue video 11 ID0
4 ID2 12 ID1
5 Ground 13 Horizontal sync
6 Analog ground 14 Vertical sync
7 Analog ground 15 ID3
8 Analog ground
Pin # Signal
-1-
4x HD-15
Female
1. Push-button Switches (Manual type)
2. Port LEDs
REAR VIEW
1. Power Jack
2. Video Output
3. Video
Input
Installation
Before the installation, make sure the peripherals of all PCs
are grounded properly and turned off.
1. Connect the VRM-1712 or VRM-1714 HD-15 female
input connector with HD-15 male to male cable from
PCs.
2. Connect the VRM-1712 or VRM-1714 HD-15 female
output connector with HD-15 male to male cable from
monitor.
3. Connect the power adapter each side.
4. The red LEDs will flash on port 1. If not, please go back
to check step 3.
5. Turn on the PCs and monitor.
6. The green on line LED lights while the PC has been well
connected with the corresponding port & is running.
-2-
Operation
1. Port Selection
Press the button of “port selection switch” for
accessing the wanted PC.
The selected corresponding port will light on for the
red LEDs which indicating the port is actived.
2. Auto Skip Function
The Auto Skip provide that Auto Skip to next ready
input port when selected port is not ready.
Press port 1 and port 2 switch of front panel of
VRM-1712 (or port 2 and port 3 switch front panel of
VRM-1714) on the same time to on/off Auto Skip
function.
The Auto Skip function is disable after VRM-1712 or
VRM-1714 power on.
© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.
-3-
Loading...