AV LINK BNC90 User Manual

Active noise cancelling Bluetooth headphone

Model No.: BNC90

User manual

Important Safety Instruction

If used in the correct method, this design and production of this product can ensure
your personal safety completely. However, any inappropriate use may lead to
potential risk and danger of electric shock or fire hazard. Please read all the safety
instructions before installing and using the product. In particular, attention shall be
given to the following information:

1. It needs to be stored or used in the ambient temperature.

2. It shall not be placed in water or wet locations.

3. It cannot be disposed randomly because it may cause environmental pollution.

4. Without approval, it shall not be disassembled or repaired.

5. The built-in lithium battery can’t be disposed in the fire or other places to

prevent causing fire hazards.

6. It shall be cleaned with dry cloth.

7. Whenever there is damage, it needs to be repaired by professional personnel.

Headphone overview

Functions

Button operation

Power on

Press and hold the MFB until the LED indicator flash green once
then flash in green and red alternatively

Power off

Press and hold the MFB until the LED indicator flashes red once
then goes off

Calls
operation

1. To answer an incoming call, tap the MFB button once; tap once

again to hang up the call. Press and hold the button twice to
reject the incoming calls

2. During the call, press and hold the MFB button for 2 seconds to

seamlessly switch the conversation between the headphone
and the mobile phone

3. When an incoming call from the third party occurs during the

call, tap the MFB button to hang up the current call and to

answer the third part’s coming call; press and hold the MFB
button to put the call on hold and to answer the third party’s

incoming call.

4. When Bluetooth is connected, press and hold the MFB button

for 2 seconds to retrie

Volume
control

Adjust the volume wheel to adjust the control until it reaches to
your desired one.

Play / pause

Tap the “MFB” once to pause music when the music is playing; Tap
once again to continue playing the music

Previous /
Next tracking

While the music is playing, tap forward button once to next track;
To move to the previous tracking, tap backward button once.

Pairing the device

1. Making sure there is power remaining in .

2. Press and hold the “MFB” button until the Led indicator flashes in green once

then in green and red alternatively which indicates that the headphone enter
had entered into pairing mode.

3. Enable searching of nearby Bluetooth devices using the Bluetooth menu on your

device.

4. Select “ ” from the Bluetooth device list on your mobile phone. If connected, the

headphone will enter into standby mode.

can be paired with two Smartphone at the same time.

If was previously paired to a Smartphone, it is possible to be paired with a 2nd
Smartphone: restart (switch off and switch on) to enter pairing mode; repeat the
above pairing procedure to pair with the 2nd Smartphone; and then reconnect with

st

1

Smartphone; finally two Smartphone can connect with .

Note:

1. The headphone will automatically connect the last paired device once it is in

effective range.

2. The headphone will be turned off automatically if no device connected within 10

minutes.

To clear the pairing list

Power on the headphone, then press and hold the forward button and backward
button until the left Led indicator flashes yellow 3 times then in green 1once every
second.

ShareMe Function

Two headphones are connected to the same device to listen to the same music or
audio program at the same time.

ShareMe paring