Avionics / Antennas / Transponder / RAMI AV-22 Transponder Antenna RAMI AV-22 Transponder Antenna Installation Instructions

AV-22 & AV-22(-1)

Transponder Antenna for General Aviation

Frequency Range: 1030-1090 MHz

Installation Instructions

1.) Mounting location should be on the belly of the
aircraft at least 18” from any other metal
protrusions and on as flat a surface as possible.

2.) Drill mounting hole (see options below) through
the aircraft skin at desired location. Remove all
burrs from around edge to allow proper seating of
moisture seal.

3.) Disassemble antenna by removing the hex nut,
lock washer and nameplate as show in the
illustration.

4.) Insert the antenna through the mounting hole
from the outside of the aircraft.

5.) Slide nameplate and lock washer over the BNC
connector of the antenna from the inside of the
aircraft. Thread the hex nut onto the BNC
connector and tighten securely.

6.) Connect the antenna to the aircraft radio using a
cable with a BNC type connector attached (not
supplied).

RAMI, Inc.
P.O. Box 858
Grand Haven, MI 49417-0858
[phone]
www.rami.com

Document #27-3414-1
Rev.: D Revised: October, 2008